When you need to transition between tile and a lower surface, the Schluter-RENO-V profile
is a great solution. Not only does the profile protect tile edges but it also eliminates
trip hazards! No matter what height floor you are transitioning
to, the profile has a moveable transition arm that is adjustable for a perfect match!
The profile is available in two anodized aluminum finishes.
All of these features make RENO-V a great choice when transitioning to lower surface
coverings. We all know that planning is important with
any tile installation. It�s even more critical when working with profiles. It�s the key
to a successful project. In our demonstration, we will be installing
tile adjacent to laminate flooring. We have selected the tile and profiles and
determined the overall layout. We will be using RENO-V to create a smooth
transition between the two floor coverings. We selected the profile height according to
the thickness and format of the tile. We also chose the transition arm length based on the
slope we wanted. In addition to tile setting tools, we will
need to choose the proper tools to cut the profiles. This will depend on what material
the profile is made of. For the RENO-V in aluminum we will be using
a chop saw or miter saw with a non-ferrous blade.
Aluminum profiles can also be cut using a variable-speed angle grinder with the Schluter-PROCUT-TSM
cutting wheel. Another option is to simply use a hacksaw
with a bimetal blade. With the planning complete, let�s prepare
for installation. The floor is now ready for the tile installation!
We have installed the Schluter-DITRA-XL uncoupling membrane where the tile is going to be set.
The laminate flooring has also already been installed.
The RENO-V profiles are installed at the same time as the tile.
This sequence may vary. It depends on your layout and installer preference.
First, measure where the RENO-V profile will be installed.
Then, transfer the measurement to the profile.
Keep in mind that we must avoid any overlap of the profile anchoring legs because this
will interfere with the tile installation. We make miter cuts to produce a clean transition
between the RENO-V profiles. Remember to always observe all safety instructions
and standards. We cut the RENO-V using a miter saw with a
non-ferrous blade. For best results, cut the profile slowly.
An accurate cut ensures a clean transition. Then, file the cut end of the profile to remove
any burrs. Dry fit the profiles.
Now we can move on to the installation Using a notched trowel, apply thin-set mortar
to the area where the RENO-V will be installed. Firmly press the anchoring leg of the profile
into the thin-set mortar and align. The next piece of RENO-V is installed the
same way. Take care to align the profiles, paying close attention to the area where the
profiles meet. You can also use KERDI-FIX or a similar adhesive
to secure the adjustable arm into place. For heavy duty applications, fill the back
of the adjustable arm with thin-set mortar. Next, we trowel additional thin-set mortar
over the anchoring legs. This is necessary to ensure full coverage and support of the
tile edges. Solidly embed the tiles into the thin-set
mortar, so that the tiled surface is flush with the top of the profile. Set the tile
up to the integrated joint spacer. This will provide a uniform grout joint.
Don�t forget to clean any excess setting material immediately from the profile to avoid
any damage to the finish. We complete the installation by setting the
remaining tiles. As you can see, the RENO-V profile is the
perfect solution when you need to protect tile edges and have a smooth transition to
lower surfaces. Another great innovation from Schluter Systems!