this is the Geberit typ 290 dual flush outlet valve
the valve is easy to install it has a simple maintenance procedure
and is fully adjustable to suit most systems
with a round button hole in the top of the system lid
the valve is also compatible with existing Geberit valves
the typ 250 and the typ 280 so you can reuse the existing basket
which is already installed into the system
there are two combinations of the valve available
one is the trade pack here and the other is the retail pack
the trade pack is designed as a direct replacement of an existing gebrete
outlet valve and the retail pack it's for retrofit
or a complete renewal of the outlet valve
everything you require to change the valve
is inside this box even a spanner to tighten up the back nut
fitting the typ 290 valve into existing typ
280 and typ 250 baskets simply push the valve into the basket
until it clicks into place and to remove the valve twist and lift
out to install the typ 290 into a 290
basket twist and click into place
to adjust the overflow height of the typ 290
you need to first slide the blue clip to unlock the overflow tube
raise or lower the height of the overflow to suit the cistern
then clip it back into place and lock it off
to raise the button height turn the blue switch anti-clockwise to unlock the
button
lift the button to the desired height and lock it off
back into place
to install the typ 290 into the cistern you first need to make sure the rubber
seal is on the bottom of the basket place the basket through the cistern
first put the back nut flange on followed by the back nut
and tighten up so it's watertight
install the foam seal if it is a closed coupler toilet suite
it fits over the top of the back nut
you next you want to set the height of the overflow to the cistern
then adjust the height of the button unlock the button and lift the button up
past the top of the cistern push it back down with the system lid
until it rests on the system
lock off the button with the switch and the height is set
to adjust the flush duration remove the valve
and slide the indicators up or down to suit your flushing requirements
reinstall the valve by twist and click into place
place the lid on top of the cistern
and tighten up the button
you can then turn the water back on and check for correct operation
for any more tips and tricks or product information head over to geberit.com.au