Hi guys it's Hik Guru here in todays video I'm going to be showing you how to setup the speaker
and light strobe settings on the HikVision G1 G2 SL series. So first off lets logon to
your NVRs web browser once you're logged in lets click on configuration at the top
and now if you haven't already got virtual host enabled if you just click on
network advanced settings, other and then just make sure that enable virtual host is ticked
then click on save now lets head on over to system on the left hand side camera management
IP camera and now you'll see there is blue links next to each camera and this will allow you to
login to that specific camera so click on the link to the camera you want to setup
login to that camera in most cases it'll be the same details as your NVR login
once your logged in click on configuration now lets click on event
and then basic event and this is where we can setup our flashing alarm light output
so you can choose your flashing duration in seconds your flashing frequency so how quickly
the strobe flashes so high is very fast flashing or you can set it to low which is
every few seconds it'll flash you can also set a schedule specific to the alarm light output.
After setting these settings just make sure you tap on save, now we can head on over to audible
alarm output so this is the audible warning that you can hear so you can change it on this list
here so attention please the area is under surveillance is our standard you can change
it to any of these lets give that a quick test "attention please the area is under surveillance"
alarm times is how many times that is going to say that warning in most cases in set it to one
so it looks a bit more believable and then sound volume I'd leave it at 100 depending on where you
fitted the camera and once again you can setup a schedule so that is different to the actual
notifications to the HikConnect app this is just for the audible alarm output schedule not the
HikConnect triggering notifying the surveillance centre just make sure after you've done the
settings you click on save and now before we set our zones up you'll want to go to smart event,
now assuming you're setting up intrusion detection you'll just want to go to
linkage method and you're going to want to tick flashing alarm and audible warning click on save.
And now lets go back onto our NVR webpage lets go down to event smart event then just choose the
camera you want so post go to intrusion and here we're just going to set our zone up like normal
so enable intrusion detection tick draw area so for this demo I'm just going to do the full screen
we've got human or vehicle detection so that's going to filter out any
nuisance filters such as cats leaves etc
if you don't tick any of these it will literally trigger at a lot more than it should
and of course threshold is the amount of time in seconds the objects got to
be in your zone before it will trigger and sensitivity leave it at 50 that's the default
lets just check our linkage method notify surveillance centre is indeed
enabled so that's going to trigger to my HikConnect app just tap on save
and yeah that is pretty much it guys just go outside make sure
it is actually indeed working it is talking to you it is flashing at you
and that is everything all done if you've got any questions or need any further help just let
me know in the comments down below and I'll get back to you but yeah take care bye bye.