we are not going to install a network
socket on this wall behind me you can
see that I've already put the bike box
in position I've already drilled the oil
and put the cable through there are two
standards when you come to installing a
network there is t568a and t568b this
socket is going to be weighed in the
t568b
standard that is the socket that we are
installing and we are using cat6 cable
to start software you need to strip some
of the outer insulation from the cable
to do that we use one of these tools
which is a dedicated tool for stripping
off the outer sheath you have to be
extremely careful when you use this you
do not want to Nick any of the wires on
the inside so use this it's very simple
you just need to press that on on that
part to open it up slide the cable in
and just go around it once once you've
done that you can then remove the tool
and when you bend the LT sheath it will
set for it and you can then pull that
part off at this point you need to
inspect the way used to make sure with
it you haven't nicks any of the way use
you can then separate the foes and then
you can cut off the piece on the sensor
and the string if you look at the socket
it's got the actual wiring colors in the
back of it so number four is solid blue
number five is blue and white number
eight is solid Brown number seven is
brown and white because we're using the
B standard we will be put in orange in
that terminal I mean your white in that
terminal solid green in that terminal
and green and white in that terminal at
this point we're not going to unravel
any of the actual twists so we're going
to get a cable tie around there you
don't want to do that too tight now it's
on that we can start to unravel the PERS
you don't want to unravel the purse too
much because that can cause more in
even's so we're going to start off up in
this top corner and we're going to
unravel the brown and the brown and wide
so that's just enough to get the bellman
weight into that terminal and the brown
into that terminal and I'm going to
unravel the orange and the orange and
wiper can now place the orange into that
terminal and the our medium white in
that circle can now unravel the green
and the green and white put the solid
green in that terminal and the green and
white in that terminal can then untwist
the blue and blue and white can put the
blue in there and finally at the blue
and white in the last remaining terminal
once you've done that you can then take
a punch down tool and you can punch down
each of the WIU's so we're just going to
push all those down and ensure that they
are pushed in fully you can I still get
some of these that actually snip off the
way over the center but they are more
expensive this is just a cheap tool once
you've pushed all the ways in you can
then go along and snip off the excess
wire once you've done that you can then
snip off the excess cable tie you can
then push the sockets back and clip them
into the core
you