okay I'm going to show you how to get this PVC pipe and something like these boards we
have here they've all been done they're thick boards also and we'll show you how
it's done so this is what we're using you see the heat guns in this tin and fits on
the hand this is a base this is to keep it all stable and to have a longer pipe of
PVC we've got a connection to make it a little bit longer so you can put longer PVC pipes in
you
we will now start off with cutting what when we move so now now it's going to cut you've
got to mark long wise and this is how we do you get a sharpie you get a straight edge we're using
this against table and all you do is mark it like this and there's your mark so now here we've put
in the vice I'll speed it up a little bit and you can see the vice is holding and you just need a
hand saw to do the job and you can see a nice straight cut look at now we're ready to heat
the pipe so now we're ready to flatten the pipe I've preheated this for about five minutes oh it's
already warm you put the PVC pipe in put it on like that as you can see these are the cotton gloves
I was talking about they quite good handling the hot PVC. I'll just speed it up a little bit
so we're just about done I'll take the heat gun off. Take the PVC pipe out which is now
soft and pliable as you can see you can lay down like a blanket and you put a board on
it I stand on about 40 seconds went off or left it for about 10 minutes by itself with this came
back and it should be OK I'll just lift it up and this is the end result nice flat board and
that's exactly how it's done so if there's any questions relating to this please ask in
the comments below and I'll attempt to answer any questions you have and well suppose THAT'S ABOUT IT!!