Hello everyone, today I show you how to disassemble iPhone X and replace motherboard
To disassemble the iPhone X you need the following tools:
• Screwdriver set • Plastic mediator
• Suction cup for removing display • Tweezers and opening plastic tool
• Hairdryer In the description under this video, I left
links to the necessary tools and parts for replacement
Before disassembly, turn off the iPhone and remove the sim card tray.
Unscrew the two screws near the charging port with a Pentalobe 0.8 mm screwdriver
Take any hair dryer and heat the surface of the screen for 1-2 minutes.
Set the suction cup at the bottom of the screen and pull the ring up.
Next, take a plastic mediator and begin to disconnect the display module from the iPhone.
The case of the iPhone 10 opening like a book.
Open the display to the right side.
Using a Tri-Wing 0.6mm screwdriver, unscrew 5 screws and remove the metal panel.
Under the metal panel, you will see cables.
The first is disconnecting the battery cable, and then disconnecting the 3 display cables
To replace the motherboard, you need to disconnect
all cables from the motherboard, unscrew a couple of screws and remove the metal frame
from the camera module.
Begin disassembly by removing the camera bracket.
Disconnect all cables from the motherboard Also, you need to disconnect one hard-to-get
cable; to do this, remove the Face ID module and it will be possible to disable this cable.
Remove the 3 screws from the motherboard and do not lose the metal part from the last screw.
Now you can remove the motherboard from the case.
What you need to know when replacing the motherboard on the iPhone X.
If you decide to install a new motherboard, also you will need to replace the Face ID
module and the light sensor.
When you buy a new motherboard, look for the kit — a motherboard with native Face ID
module and the light sensor that comes modularly with the proximity sensor and ear speaker.
If you just install a new motherboard and connect the Face ID module from your iPhone
X, then the Face ID function will not work, because the Face ID module tied to the motherboard
from the factory where your iPhone X assembled.
In the description under the video, I will leave links where you can buy a motherboard
for iPhone X Let's start the assembly with the connection
of the cables.
Connect the cable and install the Face ID module to correct position.
Fasten 3 screws and connect all cables to the iPhone 10 motherboard
Install the metal bracket on the camera module and fasten the 2 screws.
Now you can connect the display and check how the motherboard works, before the final
assembly with gluing of the case To test the iPhone, you need to connect 3
display cables and after the battery cable.
Turn over the display, but do not close the case, just flip it.
Turn on the iPhone and check how the smartphone works.
If everything is working properly, let's begin to the final assembling
Remove old glue from iPhone X case Using medical alcohol, wipe the iPhone X case
from the old adhesive tape.
If you want to restore the water resistance of your iPhone X, you need adhesive tape like
this.
Of course, you can assemble your iPhone X without this adhesive tape, but this makes
no sense because this adhesive tape costs only a couple of dollars.
In the description under the video, you find a link where to buy this adhesive tape.
Connect 3 display cables to the mainboard and only after connect
the battery cable.
Install the metal panel and fasten
the screws.
Turn over the display and press it to the case.
Fasten the 2 screws near the charging port.
Install the tray with a sim card.
Now you can turn on your iPhone X and use it