Hi everyone, welcome to HowFixit.
In this video guide, I'll show you how to replace the battery in Apple Watch Series
6
To disassemble Apple Watch 6, you'll need the following tools:
Tweezers Plastic tools
Glue - I will use B7000 glue due to its high elasticity, anti-vibration, and water resistance
properties.
Screen Disassembly Tool - This tool has a very thin curved metal blade for opening electronic
devices with a screen that is difficult to pry with a common plastic tool.
I think this is a must-have tool for disassembling an Apple Watch all series because the gap
between the screen and the watch body is so thin.
Before you start, turn off the Apple Watch 6.
For a more successful opening of the watch case, warm up the surface of the display with
a regular hair dryer.
Insert the edge of the curved blade into the thin gap between the display and the watch
case.
From this position, gradually begin to separate the display.
To avoid damaging internal components, try not to push the blade deep inside the watch.
Carefully turn the display towards the watch crown.
The Apple Watch battery is glued to the watch body, you can use isopropyl alcohol to safely
remove the battery.
Add some isopropyl alcohol under the battery and wait a bit.
Use a plastic tool to pry out the battery.
Disconnect the battery cable.
Now you can remove and replace the battery.
The replacement battery part number A2345 for the Apple Watch Series 6.
In the description, I left a link where to buy the battery for Apple Watch 6.
Use double-sided adhesive tape to re-glued the battery to the watch body.
Before gluing the display to the main housing, test the watch and check all functions.
Now you can proceed to the final part of
the assembly.
Let's move on to gluing the display with the housing, this will restore protection from
water and dust.
You can use a special adhesive sticker for your Apple Watch Series 6 or silicone glue.
In my opinion, for protection against water and dust, glue is more effective.
The B7000 glue dries completely after 24 hours, but the minimum surface drying time is 6 minutes.
So, I recommend waiting at least 45 minutes, after which you can remove excess glue.
To fix the display and the main housing, you can use clips or rubber bands.
This repair is complete, you were on HowFixit, and see you next time!