So we're gonna have to take it off the, off the base
of it so these packages be a pain in the a** to open
If you don't got the right sh*t for it (yeah) 35?
$19.99
oh
We need battery for it
Ahhhh
Oh
Ahhhhh
Daaammn boyy!
What's that?
This here is a stud finder. A stud finder has to be
calibrated using an empty section of a
wall it works by sensing the change in
density like the edge of the stud we're
basically finding the two edges of said
stud in order a pinpoint the center
that's it
the tilt arm is going to be
positioned behind your TV the name
describes its exact purpose it will
allow you to adjust the viewing angles
that best suits your comfort majority of
these screws will not be you i'm not sure
why most of these are here to begin with
whoever's doing this i recommend you not
thank you
big boy bolts
Let's start with the wall mount
i was able to download a balance
beam from the apple store that uses the
phone's built-in gyroscope in order to
accurately depict how straight the wall
mount is using the already existing
markings i was able to mark where the
screws go make sure the mark for the
crews matches your marks for the center
of thy Stud
one two three four for the support
I guess better lighting
The Tilt Arm goes behind the TV
Put the second to biggest screw
into the washer Align the spacer with the
TV screw hole underneath the tilt arm
insert the screw into the spacer
And drill it in.....
You're Gucci
( Drilling )
( Drilling in increments )
in terms of cable management you want to make the
firt hole as closest to the wall mount as
possible so that when the TV goes up the
hole is hidden so we're going to be using
this hole over here to feed the wires
we're just going to drop it in there and
down from the bottom base of the wall
the second hole should be parallel to
the first near the base of the wall
it'll make the process of fishing the
wires from the wall much easier
I'll link some datacomm electronics wall
plates down below for a cleaner look
and we're going to align this hole
with another one right down here
that's about right
No the power plug
We're... putting up the TV
I know
It made it?
Got it
the power cable for the TV wasn't
long enough to hook it up to the nearest
power outlet and the TV at the same time
so we had to improvise
connect the power cable to an extension cord
Check
zip tie the cords together so it doesn't
become undone once inside of the wall
Check!
put the cord inside of the
wall and feed the extension cable
through the wall plate if we had one
at the time of recording
Got it!
If you made it this far in the video
then you have to click the subscribe button
Not if you don't want to
but you have to
Join the Team
Peace!