Hi everyone and welcome back to the Sawickipedia. Today we're looking at the
different error codes that may be thrown up by your Bosch, Siemens, Neff, Kenmore
dishwasher. There's going to be separate videos for each error code so I've split
these up into a big playlist so you can look at your particular error code
without having to look through all the other crap about the rest of the error
codes. I'd suggest hitting the subscribe button
now just so you can easily come back to these videos whenever you need to, it's
going to make it a lot easier to find them for you, but apart from that we'll
get straight into it. The E28 code relates to a problem with the turbidity
sensor, so first thing to do just check your outlet hose make sure everything's
ok there. Otherwise remove the front panel and the bottom base plate in order
to get access to the sensor itself. Just be aware that water is likely to come out when
you remove these. So this is the water outlet or drain pipe, everything looks
clear there just remember to fasten that clip back up
otherwise you might make quite a mess. All right now before we do anything else
just make sure that the power to the dishwasher is turned off and also the water to
the dishwasher is also turned off. If you've got an inbuilt unit you will have
to remove your kick board in order to access the bottom of the dishwasher.
So in order to remove the front panel you need a Torx t15 bit, you can pick these
up from your local hardware store or electronics hobbyist store. So open up
the front of the dishwasher and you'll find a total of six Torx bits around the
back here, there are also a few up the front that holds the control panel on
but you don't need to remove those. So just remove these 6 Torx bits / Torx screws.
Alright once they're out close the door back up, grab around the bottom at the
sides and just pull outwards. Alright and now you'll have access to these screws
at the bottom here, so again they're Torx t15 bits, so remove those and
then you can just pull this out, just be careful because it is pretty sharp, and
remove this sound deadening material and now you've got access underneath. So if
you've got a multimeter handy you can also remove some of these connectors and
just check the resistance, you should be able to find online
what resistances you're supposed to have. That's about it for this video I
hope it's helped you out, the only thing I'd ask in return is for you to
subscribe to this channel which you can find a link to in the bottom corner of
this video, there's also another one popping up in the top corner of your
screen somewhere around now. So as always thanks for watching the Sawickipedia,
please hit the like button and you can leave me a comment down below. As always
thanks for watching, see you later.