Hi everyone, Welcome back to geardo,
Today we will show you how to replace the LCD screen display assembly on the
Oneplus Nord N100 mobile phone. To start, we need to have the
right tools to proceed with the repair, which You can find in the description.
First, Take out the Sim tray and then the back cover removal.
To remove the back cover, it needs to heat gently
around the back cover edges until the pasted adhesive becomes soft.
For this, we are using a heating pad. Place the back cover side on the heating
pad and Select the mobile phone HEATING option and leave it till it completes.
Alternatively, you can use a heat gun or hairdryer.
Next, create an opening using a suction cup and then insert a
plastic card pry tool or something similar to cut the adhesive around the back cover.
Next, using a heat gun, apply little heat to soften the glue on the fingerprint button.
Take out the back cover and remove the midframe by
undoing 18 screws from the top and bottom sections.
And then, Using a plastic card pry tool, create an opening to separate the back cover frame.
Be gentle and workaround on the edges to separate the plastic clips.
Next, unplug the battery connector on the right-hand side.
Next, take out the battery; first, loosen the adhesives on the sides
and then pull it by the red tab. Be gentle and lift the battery.
Next, take out the logic board by releasing two connector plugs and two antenna heads.
Next, Apply little heat and take out the earpiece.
Next, move to the bottom and undo one screw and take out the cover.
Next, move the battery protective tape to the left-hand side,
and then disconnect and take out the main flex by dragging the adhesive strip to the left-hand side.
Next, disconnect and take out both antennas from the body.
Next, take out the charging port board with the headphone jack from the body.
Next, apply little heat and take out the vibrator motor.
Now the only remaining part is the broken front screen assembly with the frame and buttons.
There are two screen types for the replacement, screen with the frame
and screen without the frame. It can be original, used, refurbished, or aftermarket.
I recommend you go with a replacement unit with the frame installed,
making the process much easier.
Next, place the earpiece in the body.
Next, place the logic board in the body. Ensure the placement
is secured and connect the lcd plug to the board.
Next, place the main flex.
Next, place the vibrator motor in the body.
Next, place the charging port board in the body.
Next, place both antennas in the body and connect them by both ends.
Next, connect the main flex from both ends and move the adhesive
strip and Protector tape to the right-hand side.
Next, place the battery in the body and secure adhesives.
Next, place the charging port cover and secure the screw.
Next, secure the battery connector and place the mid-frame by adding 18
screws and the sim tray. Make sure clips fasten.
Next, Before installing the main back cover, make sure it has enough glue on it.
If not, use B7000 glue or a new double-sided back cover adhesive.
Finally, we are adding binding clips to tighten the rear cover with the body.
If not, you can use some rubber bands and Leave them for some time.
I
hope you have enjoyed the replacement guide.
Let us know if you have any questions; please share and comment on our videos.
DO not forget to hit the subscribe button.