Hi everyone, welcome back to geardo. Today we will show you
how to replace the Speaker buzzer on the iPhone XR mobile phone.
Before Starting, we need to have the right tools to proceed with the repair,
which You can find in the description.
First, Turn off the phone, and then undo two bottom screws by using a Pentalobe Screwdriver,
To remove the front screen, it needs to heat
gently around the screen edges until the pasted adhesive becomes soft.
For this, we are using a heating pad. Place the front screen side on the pad,
select the mobile phone HEATING option, and leave it till
it completes. Alternatively, you can use a heat gun or hairdryer.
Once the heating has completed, you need a
good suction cup or something similar to create an opening.
Here we are using a double-sided suction cup to lift the front assembly.
If not, you can use a regular suction cup to raise the screen and a plastic card pry tool
or triangle picker for separation and loosen up rubber gaskets on the frame.
Lift the screen, keep the direction like opening a book,
and remove the Shield by undoing three screws. And, Then Undo the battery plug.
Next, take out both screen & earpiece connector shields by undoing six screws.
Next, undo the screw, remove the bracket,
and disconnect the earpiece assembly plug and both lcd & touch connectors from the board.
Now the front screen unit can leave from the body.
Next, take out the bracket by undoing seven screws and the connector.
Next, remove the foam sheet from the plug.
Next, remove the not-working speaker buzzer by undoing five screws with two brackets.
Be gentle and take out the speaker buzzer by cutting adhesive.
Next, Place the New speaker buzzer in the body by securing five screws with two shields.
Next, place the foam.
Next, place the bracket by securing seven screws and the connector.
Next, add the pre-cut water seal adhesive into the frame. Please
note this tape will not completely protect the device against the liquid.
Next, connect the front screen to the body. Secure the LCD & Touch,
earpiece assembly and battery plugs into the board.
Ensure the connections are secured and then turn on the device for verification.
Next, place all three shields and the bracket by adding screws. Be gentle in this process.
Next, clamp up the phone. Click in the top section first, then click sides and
the bottom simultaneously. Just make sure to put the pressure on the frame sides.
And finalize the installation by adding the sim tray and two screws in the bottom.
I
hope you have enjoyed the Repair guide.
Let us know if you have any queries; please like, share, and comment on our videos.