[Music]
domani SLR includes vanishing fender
mounts that accommodate full-coverage
fenders for added utility to best
accommodate the domani SL ARS wide tire
capabilities we recommend the bond
checker NCS 700 by 45 fenders for this
procedure we will need a three
millimeter hex wrench four millimeter
hex wrench and an eight millimeter open
end wrench as with every service process
it is important to start in a clean
environment place the bike in a repair
stand use of a traditional seat post
clamping repair stand is recommended for
this procedure remove the front wheel
remove the vanishing fender mount set
screws from the fork legs take the
vanishing fender mounts eye bolts and
hand thread the locking nuts completely
until they bottomed out
install the eye bolts with locking nuts
on the fork legs disc models will use an
angled bracket adapter that is mounted
between the caliper bolt head and the
disk caliper itself after the eye bolt
has completely threaded into the
vanishing fender mount oriented so the
flat section is perpendicular to the
ground using the eight millimeter
open-ended wrench tighten the eye bolts
locking nut until it is secure install
the top of the fender to the backside of
the four crown install the fenders lower
struts to the eye bolts at the bottom of
the fork torque the eye bolt hardware to
a max of 5.2 Newton meters reinstall the
front wheel adjust the fender at the
four crown so it is centered and there's
ample clearance between the fender and
tire adjust the lower struts of the
fender so it is centered over the tire
and there is a lease enough clearance
that the tire and fender do not rub
after finalizing the position of the
fender torque the fork crown fastener to
a max of 5.2 Newton meters and the strut
hardware to three Newton meters next we
will install the rear fender place the
bike back into the repair stand remove
the rear wheel install the eye bolts
with locking nuts just above the rear
dropouts if installing on domani disc
models install the seat Staybridge
adapter install the top of the fender to
the brake arch or sea state bridge
adapter then installed the front of a
fender
at the bottom of the seat tube with the
included fastener install the fenders
rear struts to the eye bolts at the
dropouts torque the eye bolt hardware to
a max of 5.2 Newton meters reinstall the
rear wheel adjust the rear struts of the
fender so it is centered over the tire
and there is a lease enough clearance
that the tire and fender do not rub
[Music]
after finalizing the position of the
fender remove the rear wheel once more
torque the seat tube fastener and seat
state bridge or brake arch to a max of
5.2 newton meters and the strut hardware
to a max of three Newton meters ensure
that the fender placement does not
interfere with wheel travel brake
function or any other part of the bike
system that can create a hazard thanks
for joining us today as we install
fenders on domani brought to you by Trek
certified service premium support from
trained and certified experts
you