hi I'm Marc Spehalski senior VoIP engineer and VoIP supply today we're
going to take a look at the AudioCodes MP-112 FXS gateway and we're going to
be doing a basic configuration of using analog phone and communicating with a
renegade PBX first let's take a look at what's on the back we have our power
port Ethernet port 2 fxs ports 4 analog devices and a reset button for setting
to factory defaults next we'll plug in the AudioCodes MP-112 FXS VoIP
gateway it's the power in our network so we can get started
also plug in the analog device you're going to use I'm using this analog
telephone our objective with the AudioCodes MP-112 fxs gateway is to
simply plug in an analog phone into one of the FXS ports have a communicate
with an extension on our renegade PBX to start well log in with the default
credentials which are admin for the username and admin for the password both
using a capital A
I've already changed the IP address to one that will work on my network by
default it will be 10.1.10.10 this can be changed by going to VoIP network IP
interfaces table answering it under IP address for the next step click coders
profiles coders for this example we use g.711 a with
packetization time 28 64 click Submit
next go to sip definitions click proxy and registration
we want to click yes for use default proxy click the arrow for proxy set
table enter in your PBX information
we'll be using UDP for this example click Submit
make sure always use proxy is enabled as well as enable registration well enter
some information for our VoIP PBX
make sure your subscription mode is per endpoint and registration mode is also
by per endpoint submit
now click on PSTN gateway in IP to IP click on hunk route an endpoint phone number
we'll use channel 1 and extension 2003 which is already programmed in our going
to get PBX click Submit
next go to a Analog Gateway in authentication
we will use fxs port one extension 2003 you enter the predefined password
last will click routing telephone to IP routing enter the IP address of your IP PBX
our etiquette PBX is 10.10.10.73 use port 5060 for sip set transport type to
UDP click Submit if your Audiocodes gateway has not yet
registered to the PBX you can click on endpoint phone number and click the
button that says register you could then check the status by clicking on status
and diagnostics registration status we can see that FXS port 1 is now
registered to the PBX to make sure everything's working well place a test
call from our IP phone to our analog and then from our analog to our IP phone so
first IP to analog I'll dial 2003
now from the catalog I'll dial 2002 it looks like they both work finally our
last step to make sure everything is saved click on the burn button in the
analog VoIP Gateway and that's all there is to it so we've set up our AudioCodes
mp-112 FXS gateway to use analog phone with a renegadePBX
for any other questions regarding the AudioCodes MP-112 Gateway you can call us at