Eddie Platform Kit Setup Guide
Disconnect the power, USB cable and Carousel cable.
The kit includes the following:
Two risers.
Four Phillips screws (1 extra).
A silicone mat.
A platform and a receiving plate with three Pems (attached nuts).
To get started, open the top section. You may want to move the carousel and carousel platter out of the way for easier access.
Use a short #1 Phillips screwdriver (included) to remove the three screws under the existing platform.
Remove the existing tongue/platform and set it aside.
Locate the platform, receiving plate, and screws. Use the new screws!
Make sure the platform is oriented so the larger row of holes is closer to the front.
The raised Pem nuts should face up.
We'll need to align the three holes in the receiving plate with the holes in the back of the plate.
Place a screw through the first hole.
Align the protruding screw with the first hole in the platform.
Now align the protruding screw with the receiving plate.
Hold it in place by clamping it together with your thumb and pointer finger.
Now turn the screw.
Make sure the platform is oriented so the larger row of holes is closer to the front.
Align the holes in the bracket, the platform, and the receiving plate. Install the remaining screws.
Close the upper section.
Gently pull out the platform by hand.
Remove the silicone mat from its protective paper and install it.
Install or remove the risers by gently squeezing the sides as you align the tabs with the larger holes in the platform.
Single Riser Mode.
Double Riser Mode.
Reversible installation.
No Riser Mode. Print items between 1" - 2". (2.54 cm - 5.08 cm)
Dishwasher-safe silicone mat and risers.
Works with custom trays.
Works with Carousel in single riser mode only.