Hello, friends!
My name is Victor and I greet you on my channel.
Today I will show you the process of building a rack for a drill shown in the past video.
First I made a simple drawing of a base part made of thick plywood, then I made this part
with an electric jig saw.
I wanted to make a drill stand so that you could easily do it yourself without using
welding.
It seemed to me that the base part was not strong enough, so I made one more same detail
and glued them with glue.
So the glue is dry and I can start making the fastener to the base.
I have two angles 50 mm wide and a bolt 8 mm in diameter.
In the base part and corners I drilled 8 mm holes.
In the base part, I need to make a 90 degree hole to the surface as accurately as possible,
if you do not have a drilling machine yet, you can do it with a wide angle, as I showed
you in the video.
The accuracy of the hole is quite sufficient for this purpose.
I installed the supports on both sides of the angle grinder, so that the angle grinder
would have a more accurate fixation in place.
I also made grooves for fastening clamps.
This also contributes to a more accurate fixing of the angle grinder.
I rounded the edges of the corners, this is necessary for easier movement of the base
part around the axis.
For me, the angle of cutting is 90 degrees, so I made this choice.
You can come up with your own design, which allows you to cut parts with different angles.
Now I can start making the base of the machine.
I made it from a thick chipboard.
Such a solid base will ensure the immobility of all installed parts and as a consequence,
the accuracy of the cut.
Of course, you do not need to round off the corners of the platform, this does not affect
the quality of the entire product.
As the legs, I used 4 rectangles 5 by 5 cm, I glued them all with the same glue, and the
size of the platform 38 by 50 cm.
The
platform is ready and I proceed to install the axis and assemble the entire mechanism,
it's easy, you have to tighten the nut not much and not weakly, then twist the second
nut to prevent spontaneous unscrewing of the nuts.
I bought very good clamps for fixing the angle grinder, they were strong clamps for fixing
the critical parts.
To return the angle grinder to a non-working position, you can use such a return mechanism
consisting of a single spring and two fasteners.
For me, the angle of cutting is 90 degrees, so I made this choice.
You can come up with your own design, which allows you to cut parts with different angles.
This concludes my video.
If you think this video is useful, please click on like.
Thank you for watching my videos.
Bye.