Hello everyone, today I show you how to disassemble iPhone XR and replace the battery.
To disassemble the iPhone XR you need the following tools:
• Screwdriver set • Tweezers
• Opening plastic tool • Plastic mediator
• Suction cup for removing display In the description of this video, I left links
to the necessary tools and parts for replacement.
Before disassembling, turn off the iPhone and remove the sim card tray.
Unscrew two screws near the lightning port.
Using a hairdryer, heat the display surface for 1-2 minutes.
In this way, the glue heat between the iPhone case and the display, so it will be easier
to open the case.
Apply the suction cup to the bottom edge of the display and pull up on the ring.
Next, push the plastic mediator between the display and iPhone case.
If you cannot do this with a plastic mediator, take any thin plastic card and insert it between
the case and the display, then it will be easier to pry with a mediator.
Now, evenly and slowly, open the display around the perimeter of iPhone.
The iPhone case opens like a book; the display opens to the right side.
Using a Tri-Wing screwdriver, unscrew the 3 screws and remove the metal panel.
Now you can disconnect the battery cable from the mainboard.
Next, unscrew the 2 screws and remove the second metal panel.
Unscrew another 3 screws with a Tri-Wing screwdriver and two screws with a PH00 screwdriver.
Disconnect 3 cables of the display from the mainboard.
For replacing battery on the iPhone XR, I recommend remove the Taptic Engine and the
speaker, so that it is easier to remove the adhesive tape from under the battery.
Unscrew 7 screws.
Disconnect the cable.
Unscrew 2 screws and remove metal panel.
Disconnect the cable, which is located between the speaker and Taptic Engine.
Unscrew the one screw on the speaker and do not lose the metal part, which is located
under the screw.
Unscrew 2 screws on the Taptic Engine.
Now you can remove the Taptic Engine from the iPhone case.
Using a flat screwdriver, unscrew the two screws at the bottom of the speaker.
Now the speaker can be remove.
Note that the speaker glued to the bottom of the case.
To keep the factory adhesive tape, use a hairdryer to heat the place where the
speaker glued.
Slowly pull one adhesive tape away from the battery.
In the same order repeat with the other three adhesive tapes.
In the description of this video, I left a link where you can buy a new battery for iPhone
XR.
The battery should be glue to the metal surface of the iPhone case.
Apply the adhesive tape and install the battery in housing of iPhone.
Install the speaker to the case.
Fasten 2 screws.
Install the metal part and fasten the screw.
Install the Taptic Engine and connect the cable.
Fasten 2 screws to the Taptic Engine.
Between the Taptic Engine and the speaker install the metal panel and fasten 2 screws.
Connect the antenna cable.
Fasten 7 screws.
Remove the old adhesive tape from the iPhone case.
After, using medicine alcohol wipe the surface of iPhone case and display module.
Take a new adhesive tape and apply on the case.
With this tape, you keep the iPhone waterproof.
I left a link where you can buy this adhesive tape in the description.
Connect 3 display cables to the mainboard and only after that connect the battery cable.
Next, install all panels and fasten screws.
Now turn over the display and press the display to the case.
Fasten 2 screws near the lightning port.
Installing a sim card and now you can turn on the iPhone XR.
Good luck.