Hi everyone, Welcome back to geardo,
Today we will show you how to replace the back camera on the google pixel 4xl mobile phone.
To start, we need to have the right tools to proceed with the repair,
which You can find in the description.
First, turn off the phone and follow the back cover removal.
For this, we are using a heating pad. Place the back cover side on the heating
pad and Select the mobile phone HEATING option and leave it till
it completes. Alternatively, you can use a heat gun or hairdryer.
Once the heating has completed,
Use a suction cup to create an opening between the frame and rear cover.
Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.
While removing the back cover, be gentle. The flash sensor plug connects with the back cover.
Next, take out the bracket by undoing four screws to undo the battery plug.
Next, take out the sensor bracket by undoing
two screws. Please note one screw is missing on our device.
And then disconnect the plug to release the back cover from the body.
Next, loosen the logic board to take out the not working rear camera.
FIrst, take out the left bracket on the board by undoing three screws.
Next, take out the right upper bracket by undoing three screws.
Next, take out the right center bracket by undoing four screws.
Next, unplug eleven connector plugs, the antenna head from the logic board.
ALso, make sure to take out the sim tray.
Next, undo the screw securing the rear camera unit.
Next, gently lift the board and pull out the broken rear camera unit.
Both rear camera connectors are on the front side of the board while cables go under the board.
Next, place the new back camera in the body, Be gentle and insert the cables through the board.
Next, secure the logic board in the body.
Next, secure the camera screw.
Next, secure eleven connector plugs, including two rear camera plugs and
the antenna head to the board.
Next, place the right-center bracket by adding four screws.
Next, place the upper right bracket by adding three screws.
Next, place the left bracket by adding three screws.
Next, connect the bak cover sensor flex to the board and place the bracket by adding two screws.
Once again, our device has one screw, but yours should have two.
Next, secure the battery plug and place the bracket by adding four screws.
Next, Before installing the main back cover, make sure it has enough glue on it;
if not, use B7000 glue or a new double-sided back cover adhesive.
Finally, we are adding bonding clips to tighten the rear cover with the body.
If not, you can use some rubber bands and Leave them for some time.
I hope you have enjoyed the replacement guide.
Let us know if you have any questions. Please, like, share, and comment on our videos.
DO not forget to hit the subscribe button.