Brought to you by 1AAuto.com, your source for quality replacement parts and the best
service on the Internet.
Hi, I'm Mike from 1A Auto.
I hope this how-to video helps you out, and next time you need parts for your vehicle,
think of 1AAuto.com.
Thanks.
In this video, we're going to show you how to remove and replace the front speaker on
this 2003 Mercury Mountaineer.
We show you on the driver side, but the passenger side is a similar procedure.
The tools that you're going to need for this include a 7mm and 6mm socket and ratchet,
and a flat blade screwdriver.
You want to make sure that your courtesy lights don't stay on, so you don't drain your battery
so just make sure you turn those off.
Pry out from the bottom of this panel with a flat blade screwdriver, and then just slide
the panel towards the front of the vehicle and off the door handle.
Then lift up on the front of your switch panel, and then slide it forward and up.
Then just push the tabs on these harnesses and disconnect them.
For this last one, you're going to want to use a flat blade screwdriver and just push
in on the tab, pull it free, and your switch panel is free.
Now, you want to remove this 7mm bolt and these two 7mm bolts right here.
We'll just fast-forward as Mike does that.
Pry out this switch, then just pry out the tab on the harness, disconnect the harness,
and just feed that back through the door panel.
Lift the door panel up, pull it back, push the tab on this harness to disconnect it,
and your door panel is free.
Now remove the four 6mm bolts that hold in the speaker.
Push the tab on the harness and disconnect it, and your speaker's free.
Now reconnect the harness to your speaker, and you may need to do some wiring if it's
a different aftermarket speaker and just splicing the wires.
Then, once you get it back into place, replace those four 10mm bolts and tighten them up.
To replace your door panel, just reconnect this harness and make sure you push the harness
through for your mirror switch, and then push the door panel into place and slide it down.
We'll fast-forward as Mike replaces those three 7mm bolts and tightens them up.
Reconnect this switch and push it back into place.
Then reconnect your switch panel, and slide the back in first, and then push the front
end down.
Then slide this panel back over the door handle, and push those tabs back into place.
Then push in the front.
You're all set.
We hope this video helps you out.
Brought to you by www.1AAuto.com, your source for quality replacement parts and the best
service on the Internet.
Please feel free to call us toll-free, 888-844-3393.
We're the company that's here for you on the Internet and in person.