repair clinic encourages you to perform this procedure safely
in this video we will show one or more of these icons
to alert you when to use caution
as with any repair be sure you've unplugged the appliance before beginning
your first step is to remove the front lower access panel by uninstalling the
mounting screws and pulling the panel down and away
next
removed the screws at the rear of the top panel
and pull the panel off
now carefully pull off the trim ring
be aware this will probably require some effort
pull out the dispenser drawer depress the locking tab and remove the drawer from
the control panel
remove the mounting screws from the dispenser housing
now use a flat head screw driver to assist in prying loose the control panel
and move the panel out of the way
your next step is to use a small screwdriver to help remove the spring
clamp from the old door boot seal
pull the seal off of the loop of the front panel
and remove the front panel mounting screws at the bottom
then at the top
and slide the front panel out and away from the cabinet
disconnect the latch assembly wires
and set the front panel and door aside
next pull the dispenser tube free from the boot
loosen the screw on the clamps securing the boot seal to the top
and pull off the clamp in the old boot seal
you're now ready to install the new door boot sea;
with the tab on the seal pointing upward push the boot's grooved edge over the lip
of the tub
and work your way around the tub opening
replaced the clamp
and tightened the screw
insert the dispenser tube into the seal
replace the front panel indoor by first reconnecting the latch assembly wires
then slide the panel up under the control panel bracket
and secure the mounting screws at the top
and bottom
position the new boot seal over the lip of the front panel
replace the spring clamp to secure the seal
making sure the spring is at the bottom
reposition the control panel and snap it into place
reinstall the screws in the dispenser housing
replaced the dispenser drawer
align the trim ring and snap it into place
reposition the top panel
and secure the screws
replace the front lower access panel
and secure it with the screws
you are now ready to plug the appliance back in
to make sure it's functioning properly