The first time you set up your printer you'll need to install the printhead and
the ink cartridges.
When you run low on ink you'll need to replace the ink cartridges.
This video shows you how to perform these actions.
First we'll install the ink cartridges.
Press the Power button to turn the printer on.
Next open the ink cartridge cover.
Remove each new in cartridge from its package.
Push each cartridge into its slot.
Do not force the cartridges into the slot.
Each cartridge is designed for its assigned slot only.
If the cartridges do not snap into place, check to make sure that the color coding
on the cartridge matches that on the printer. If it does not find the right
color coded slot.
When all cartridges have been installed
close the ink cartridge cover.
This printer has both ink cartridges and printheads.
The ink cartridges store the ink and the printheads fire drops of ink onto the
paper to create your prints.
You'll have to replace the ink cartridges regularly but the printheads should not
have to be replaced very often. Open the top cover to access the printheads.
The carriage should automatically move all the way to the left.
If it does not,
press and hold the Resume button on the printer control panel until the carriage
moves all the way to the left.
Be careful not to proceed until the carriage is on the left side of the
printer.
If the carriage has not moved to the left after holding down the Resume
button,
turn the printer off
and back on again and then try holding down the Resume button again.
The printhead can be damaged if the carriage is not all the way to the left
for installation.
Lift the blue printhead latch.
While the new printheads are still in their packages,
shake them 6 times.
Shaking the printheads helps prevent print quality problems later.
Remove the new printheads from their packages.
Remove the orange protective caps.
Be careful not to shake the printheads after removing the orange caps.
Insert each printhead into its color coded slot.
Lower the printhead latch and snap it into place.
Close the top cover.
After replacing the printheads, the printer will calibrate and then print out
an alignment sheet. Once the alignment page prints, you can begin using your printer.
Replacing the ink cartridges is almost as easy as the first time you installed them.
Press the Power button to turn the printer on.
Open the ink cartridge cover.
Remove the old ink cartridge from its slot.
Remove the new ink cartridge from its package.
Push the new cartridge into its color coded slot.
Close the ink cartridge cover.
Replacing the printheads is
similar to the way you installed them.
Open the top cover to access the printheads.
To access the printheads you must press and hold the Resume button on the printer
control panel until the carriage moves all the way to the left.
Be careful not to proceed until the carriage is on the left side of the
printer.
If the carriage does not move to the left after holding down the Resume button,
turn the printer off
and back on again and then try holding down the Resume button again.
The printhead can be damaged if the carriage is not all the way to left for
installation.
Lift the blue printhead latch.
On the printhead that needs to be replaced lift the blue handle.
Then, use the handle to pull the printhead straight up and remove it from
the printer.
While the new printheads are still on their packages
shake them 6 times
Shaking the printheads helps prevent print quality problems later.
Remove the new printheads from their packages.
Remove the orange protective caps. Be careful not to shake the printheads
after removing the orange caps.
Insert the printhead into its color coded slot.
Lower the printhead latch and snap it into place.
Close the top cover.
After replacing the printheads, the printer will calibrate and then print out
an alignment sheet. Once the alignment page prints you can begin using your printer.
Your printer is now ready for regular use.