Hello everyone, today I show you how to disassemble iPhone XR and replace display module
To disassemble the iPhone XR you need the following tools:
• Screwdriver set • Tweezers
• Opening plastic tool • Plastic mediator
• Suction cup for removing display In the description of this video, I left links
to the necessary tools and parts for replacement Before disassembling, turn off the iPhone
xr and remove the sim card tray.
Unscrew two screws near the lightning port.
Using a hairdryer, heat the display surface for 1-2 minutes.
In this way, the glue heat between the iPhone case and the display, so it will be easier
to open the case.
Apply the suction cup to the bottom edge of the display and pull up on the ring.
Next, push the plastic mediator between the display and iPhone case.
If you cannot do this with a plastic mediator, take any thin plastic card and insert it between
the case and the display, then it will be easier to pry with a mediator.
Now, evenly and slowly, open the display around the perimeter of iPhone.
The
iPhone case opens like a book; the display opens to the right side.
Using a Tri-Wing screwdriver, unscrew the 3 screws and remove the metal panel.
Now you can disconnect the battery cable from the mainboard.
Next, unscrew the 2 screws and remove the second metal panel.
Unscrew another 3 screws with a Tri-Wing screwdriver and two screws with a PH00 screwdriver.
Disconnect 3 cables of the display from the mainboard.
Unscrew 3 screws on the speaker and one screw near the light sensors.
Pry the metal panel that holds the light sensor.
Using a plastic opening tool, carefully peel off the speaker cable and proximity sensor.
Now take the tweezers and pry the bottom of the light sensor.
If this sensor is damage, the Face ID will be lost, so special care is required not to
damage one of these components during removal and replacement of the display.
In the description of this video, I left links where you can buy new display for iphone xr.
First, install the proximity and lighting sensors on the new display.
After installed the light sensor, set on top the metal panel.
Set speaker and fasten 4 screws.
The display module assembled, now you can install the display and test how everything
works before final assembly with gluing the iPhone case.
For test the iPhone, connect 3 display cables to the mainboard and only after that connect
the battery cable.
Turn over the display and turn ON the iPhone.
Check how the phone works and, if everything is in fine, let’s go to the gluing of the
case.
Remove the old adhesive tape from the iPhone case.
After, using medicine alcohol wipe the surface of iPhone case and display module.
Take a new adhesive tape and apply on the case.
With this tape, you keep the iPhone waterproof.
I left a link where you can buy this adhesive tape in the description.
Connect 3 display cables to the mainboard and only after that connect the battery cable.
Next, install all panels and fasten screws.
Now turn over the display and press the display to the case.
Fasten 2 screws near the lightning port.
Installing a sim card and now you can turn on the iPhone.
Good luck.