Installation and Use of the High-Bright Remote Monitor
With the 4D Video Transmitter and High-Bright Remote Monitor
DJI Ronin 4D can achieve multi-channel wireless video transmission
for monitoring
playback
and transcription
Installing and activating
Rotate and install four antennas to the remote monitor
Slide the DJI WB37 Intelligent Battery
into the compartment on the back of the remote monitor
Press the power button on the left side of the monitor
for one second to power on
Use the standard USB-A to USB-C Cable
to connect the remote monitor parameter adjustment port
to the computer
Do not power off or disconnect before the activation is done
Run the DJI Assistant 2 Ronin Series
and choose Ronin 4D
Click Activate on the activation page
and follow the steps to activate
Installing the 4D Video Transmitter
Press the battery release button on the battery compartment
to remove the intelligent battery
Remove two M4×19 screws
and then the battery compartment
Push the 4D Video Transmitter
against the back cover of the main body
and tighten up three M4 screws on the transmitter
Rotate and install four antennas to the video transmitter
Push the battery compartment against the video transmitter
and tighten up two M4 crews
Insert the battery to the compartment to finish installation
Linking
Go to OcuSync on the menu of the High-Bright Main Monitor
and tap Link Device
or hold the linking button on the video transmitter for five seconds
to enter linking state
The linking status indicator then blinks red and green alternately
Tap the bottom left corner of the remote monitor
to open System Settings
Go to Connection Settings
Control Mode
Control Monitor A
and tap Link to Control Monitor A
With successful linking
the linking indicator on the video transmitter turns solid green
The remote monitor shows current linking status
You can now check the live camera view or control parameters
on the remote monitor
Using the Remote Monitor
Live camera view comes with
display and control of all parameters
Besides setting aperture and focusing parameters
you can also use safe area
LUT
exposure assistance
and focusing assistance to facilitate shooting
To ensure stable transmission
you can switch between multiple signal channels
Under Auto mode
the system automatically switches the channels
according to the interference
You can also manually switch
according to your needs under special circumstances
It is recommended to
use a stable channel with little interference
You can also set the max bandwidth for video transmission
Auto mode is recommended
Under Control mode
you can directly adjust
common exposure parameters on the screen
The adjustment will be synchronized to
the main body of Ronin 4D and other connected monitors
You can also attach the dedicated Remote Monitor Cage
to the hand grip to control focus and gimbal
and start stop recording remotely
Note that when two remote monitors are used for
controlling focus and gimbal respectively
connect to Monitor A and then Monitor B
Otherwise
Monitor A may disconnect
To enable more monitors
go to the home menu on the main monitor
tap OcuSync
and enable Broadcast mode
Once the Broadcast mode is enabled
it will automatically search for the Ronin 4D that is broadcasting
enabled automatically after connection under Control mode
and then you can select and start monitoring
When there are several Ronin 4Ds
at different positions in the same scene
you can switch between different cameras
You can also set camera numbers on the main body