good morning guys the moment of truth
everybody's awake
I don't have any kids asleep so now I
can start this thing open header I don't
have anyone cooled in it i don't have
any training fluid this is more of an
initial start make sure everything at
least starts electricals good before you
put the finishing touches to itself
here goes nothing
no four guards it lives guys
it started
did you hear that I gotta work and so
guys this morning i started the car and
it started but now I gotta work on the
header the header on a GSR and that goes
with pre 97 was longer or a shorter and
do not have an o2 sensor bone above that
they were extended and they had a 02
bung in their pre cat my buddy when he
was at the junkyard
he had me 20 swap he actually gave me
the secondary pipe from the b20 which is
longer and if you line enough next to
the DX header which you'll notice is the
length is the same and there's an o2
sensor bunk so my thought is since it's
the same length as the DX better the NOC
exhaustion bolt up to that and I get the
extended piece of the o2 sensor bump
meaning i don't have to get anything
well to that and everything will fit so
now it's just a matter of cracking off
the secondary piece on the GSR manifold
without breaking a bolt which is gonna
be tricky can get it at home so I'm
going to work on that hopefully get the
exhaust on and then i have to do is for
coolant transmission fluid and we're
ready to Rome
so there's all three side-by-side 1960s
rb20 which is the newer GSR model the DX
header so bold that guy up and hopefully
fix all my problems
two
when
haha
alright guys it is time now to go to the
exhaust shop down the street I have to
get the exhaust extended by about three
inches the annakut shorter than the
manifold on the DX header the pre-2008
GSR headers do not have an o2 sensor
bong in them so they're shorter if I
swapped it over to an LS letter or a 0
2000-2001 header from a GSR would fit
perfectly but i'm just gonna have them
cut it
they're gonna extend the anaka and
they're going to put an o2 sensor bung
sow should be fairly easy should be
fairly quick not too expensive since i'm
a few guys can see that enough but they
added in a little section of stainless
and i already had flared it better right
on we're gonna get let's start off with
the knocker exhaust hooked up for the
first time for me to that