Raise the rear of the car and secure on supports.
Remove the hub bearing protection cap. Use a hammer. Use a flat chisel.
Use a drive socket No.30. Loosen and remove the hub nut.
Remove the retaining ring. Use a circlip remover.
Press out the wheel hub bearing.
Clear the components and apply a thin layer of grease on the bearing seat. Use a wire brush.
Press a new bearing into the wheel hub.
Install the retaining ring. Use a circlip remover.
Install a brake drum.
Screw the hub nut. Use a drive socket No.30.
Install the hub bearing protection cap.