Welcome to HowFixit and in this video, I will show how to replace the speaker on iPhone
11 Pro What tools you will needed to disassemble
the iPhone 11 Pro: Screwdriver set
Plastic mediator Suction cup for removing display
Tweezers Plastic opening tool
Adhesive tape for restore water protection In the description under the video, you will
find links where to buy all these tools and replacement parts for iPhone 11 Pro
Turn off the iPhone, then near the charging port, remove 2 screws with a 0.8 mm Pentalobe
screwdriver.
Next, take a hairdryer and heat up the display surface.
The required heating temperature is 60-70 degrees Celsius, the maximum is 80 degrees.
Fix the suction cup on the bottom of the display, then take a thin plastic mediator.
Pull the suction cup ring up and begin to disconnect the display from the iPhone case.
Open the iPhone 11 Pro by turning the display to the right side, like a book.
Hold the display or place something behind the display.
Then remove the 2 screws on the small panel and the 6 screws on the large panel.
First disconnect the battery cable, after 3 cables from the display.
Replacing the speaker on the iPhone 11 Pro is a quite simple repair and almost everyone
can repeat it.
To begin, remove the 4 screws and remove the metal panel.
The second battery cable is located under the metal panel, turn it off, and also turn
off the speaker cable.
Remove the 2 screws with a Phillips 1 screwdriver and one screw with a 1.5 mm Standoff screwdriver.
In the iPhone 11 Pro, the speaker is glued to the case and, if you want to keep the factory
adhesive tape, heat the surface with a hairdryer and remove the speaker.
That's all, the speaker removed, and also saved the adhesive tape on the case.
In the description under the video, I left link where to buy a new speaker for the iPhone
11 Pro.
Let's begin to the assembly and installation of the speaker.
Install the speaker and secure with three screws.
Connect the speaker cable and after the battery cable.
Install the metal panel on top and fasten the 4 screws.
Now you can connect the display and check how the iPhone works.
To test the iPhone 11 Pro, just connect 3 cables from the display and after the battery
cable.
Turn the display over and turn on the iPhone.
Make sure the smartphone is working correctly, check all the functions, and if everything
works fine, you can begin to the final assembly with restoration of protection against water
and dust.
Remove the silicone tape from the case of iPhone 11 Pro.
Now you can wipe the case with isopropyl alcohol, this is not necessary, but it certainly will
not be superfluous.
Take a adhesive waterproof tape, but before stick it on the iPhone case, make sure to
glue it with the right position on the case.
This silicone adhesive tape restores protection against water and dust, but it doesn't provide
100% protection for your smartphone from water.
Press the sticker down so it sticks better to the case.
If you don’t have such a sticker, in the description under the video you will find
a link where to buy it.
Now let's connect the display module.
First connect 3 display cables to the mainboard and only then connect the battery cable.
Install the panels and fasten all the screws.
Turn the display over and push it to the iPhone case.
It remains to fasten 2 screws near the lightning port, and you can turn on your smartphone.
I hope this video was useful for you, and I helped restore your iPhone 11 Pro.
See you soon on HowFixit.