Required Tools: Wire brush Nylon cleaning brush WD-40 spray
Brake cleaner Copper grease Torx bit T30 Drive socket # 12 Drive socket # 18 Wheel impact socket #17
Ratchet wrench Torque wrench Tap wrench Brake caliper wind back tool Crow bar Wheel chock
1. Unscrew the brake fluid reservoir cap.
2. Raise the front of the car and secure on supports.
3. Unscrew the wheel bolts.
Use wheel impact socket #17.
4. Clean the brake caliper fasteners.
Use a wire brush. Use WD-40 spray.
5. Unscrew the brake caliper fastening.
Use a drive socket #12. Use a ratchet wrench.
6. Spread the brake pads.
Use a crowbar.
7. Remove the brake caliper.
8. Remove the brake pads.
9. Clean the brake caliper bracket fasteners.
Use a wire brush. Use WD-40 spray.
10. Unscrew the caliper bracket fastening.
Use a drive socket #18. Use a tap wrench.
11. Remove the caliper bracket
12. Clean the brake disc fasteners.
Use a wire brush. Use WD-40 spray.
13. Unscrew the brake disc fastening
Use Torx T30. Use a ratchet wrench.
14. Remove the brake disc.
15. Clean the hub. Use a wire brush.
Treat the contacting surface. Use copper grease.
16. Install the brake disc.
17. Tighten the brake disc fastening. Use Torx T30.
Use a torque wrench. Tighten it to 9 Nm torque.
18. Clean the brake caliper bracket from dirt and dust.
Use a wire brush.
Use a brake cleaner.
19. Install the brake caliper bracket
20. Tighten the brake caliper bracket Use a drive socket #18.
Use a torque wrench. Tighten it to 75 Nm torque.
21. Treat the brake caliper piston.
Use a nylon cleaning brush. Use a brake cleaner.
22. Press in the brake caliper piston.
Use brake caliper wind back tool.
23. Install the brake pads.
24. Install the brake caliper and fix it. Use a drive socket #12.
Use a torque wrench. Tighten it to 40 Nm torque.
25. Treat the surface where the brake disc contacts the wheel rim.
Use copper grease.
26. Clean the brake disk surface.
Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
27. Screw in the wheel bolts.
Use wheel impact socket #17.
28. Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17.
Use a torque wrench. Tighten it to 120 Nm torque.
AUTODOC recommends: Check the brake fluid level in the expansion tank and refill if necessary.
29. Tighten the brake fluid reservoir cap.
AUTODOC recommends: Without starting the engine, press the brake pedal several times until you feel significant resistance.