Welcome to my video of building a Voron afterburner for Ender3 v2.
This is the second episode: assembly and test print
In my last video, I prepared all the printed parts
and ordered the required the fasteners, now, It is the time
to share with you how I put them together, and more importantly,
to figure out if it really improves the print quality
let's start by taking the hot end mounting plate out from the printer.
You can take it out easily by undoing the bottom screw.
and leave the top two screws as they are
for the preparation, you also need to install the hot melt insert nuts
then you're good to go
by the way, fusion 360 is gonna be very handy when
you try to figure out what screws to use
The assembly process is easy if you follow my order
Well it's only easy if you follow my order (LOL)
Enjoy the time lapse and i will be back for the print quality comparison later
(Make sure you follow the same wiring if you use Ender 3 v2 4.2.2 stock board) Black->Blue->Green->Red
(Extruder Calibration My new extruder steps/mm is 428.5)
I really appreciate you are still watching
Here the test print. can you really tell which one is printed
from the afterburner?
leave your comments
Thanks again and see you next one.