Hello everyone, today I show you how to disassemble iPhone XS and replace camera module
To disassemble the iPhone XS you need the following tools:
• Screwdriver set • Tweezers
• Opening plastic tool • Plastic mediator
• Suction cup for removing display • Hairdryer
In the description of this video, I left links to the necessary tools and parts for replacement.
Before disassembling, turn off the iPhone and remove the sim card tray.
Unscrew two screws near the lightning port.
Using a hairdryer, heat the surface of the display for a one minute.
This will make it easier to separate the display from the iPhone case.
Apply suction cup to the bottom edge of the display and pull up on the ring.
Push the plastic mediator between the display and iPhone case.
Now carefully separate the display from the iPhone case.
Open iPhone by swinging the display to the right side, like the cover of a book.
Next, unscrew the 4 screws on the metal panel using a Tri-Wing screwdriver and one screw
using a PH00 screwdriver.
Now you can remove the metal panel.
Disconnect the battery cable from the mainboard and 3 cables of the display.
Now you can remove the display.
Unscrew 2 screws and remove metal panel.
Disconnect 2 camera cable by prying them up from mainboard.
Gently pry up camera and remove from iPhone XS frame.
In the description under the video, I left a link where you can buy a new camera for
the iPhone XS Install the rear camera on iPhone XS frame
and lightly press on camera.
Set metal panel and fasten 2 screws.
Now you can install the display and test how camera works before final assembly with gluing
the iPhone case.
Connect 3 cables from the display module to the mainboard and only after that connect
the battery cable.
Turn on the iPhone and let's check how everything works.
If the phone works well, the next step is final assembly with gluing.
Remove the old adhesive tape from the iPhone case.
Using medicine alcohol, wipe the surface of the iPhone housing where old tape was located.
Now, take new adhesive tape and apply to the case.
With this tape, you save waterproof resistance of your iPhone.
I left link in description where you can buy this adhesive tape.
Connect 3 cables from the display to mainboard and only after that connect battery cable
to the mainboard.
Set metal panel and fasten 5 screws.
Turn over the display and press down the display around the perimeter of surface.
Fasten two screws near the lightning port.
Now you can turn on the iPhone and use it.