1. Unscrew the oil filler plug.
2. Lift the car using a jack or place it over an inspection pit.
AUTODOC recommends: The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Required tools: All-purpose cleaning spray Drive socket # 12 Drive socket # 17 Drive socket # 32
Ratchet wrench Torque wrench Funnel Oil drain pan Fender cover
3. Undo the fasteners of the oil pan lower cover. Use a drive socket #12.
4. Remove the oil pan cover.
5. Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
6. Put a waste oil container with at least 6 l capacity under the drainage hole.
7. Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench.
8. Drain the used oil.
AUTODOC recommends: Caution! The oil may be hot.
9. Prepare a container for the old oil filter.
10. Unscrew the oil filter. Use a drive socket #32. Use a ratchet wrench.
11. Remove the oil filter. Put the old oil filter in the container.
AUTODOC recommends: Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
12. Clean the oil filter seat.
13. Lubricate the rubber seal of the new filter with a little amount of fresh oil.
14. Screw the new filter into its place. Use a drive socket #32.
Use a torque wrench. Tighten it to 23 nm torque.
AUTODOC recommends: Wait until the oil has completely drained from the drainage hole.
15. Clean the area of the oil pan drainage hole.
16. Screw in the new drainage plug and tighten it. Use a drive socket #17.
Use a torque wrench. Tighten it to 30 nm torque.
17. Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
18. Reinstall the oil pan lower cover.
19. Tighten the fasteners of the oil pan lower cover. Use a drive socket #12.
20. Lower the car.
21. Remove the oil filler cap. Insert the funnel.
22. Pour oil into the engine through the filler. Required amount of oil: 5.5 l.
AUTODOC recommends: Use the oil recommended by the manufacturer.
23. Check the oil level using the dipstick. Top up oil if necessary.
Please note! The oil level should be between the Min and Max marks.
24. Tighten the oil filler cap.
25. Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.
26. Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.
Please note! The oil level should be between the Min and Max marks.
Make sure that the oil filler cap is properly tightened. Check the threaded plug of the drainage hole and the oil filter seal for tightness.
If necessary, carefully tighten them up. Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system,
may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out.