Hello everyone, today I show you how to disassemble iPhone XS and replace display module
To disassemble the iPhone XS you need the following tools:
• Screwdriver set • Tweezers
• Opening plastic tool • Plastic mediator
• Suction cup for removing display In the description of this video, I left links
to the necessary tools and parts for replacement.
Before disassembling, turn off the iPhone xs and remove the sim card tray.
Unscrew two screws near the lightning port.
Using a hairdryer, heat the surface of the display for a one minute.
This will make it easier to separate the display from the iPhone case.
Apply suction cup to the bottom edge of the display and pull up on the ring.
Push the plastic mediator between the display and iPhone case.
Now carefully separate the display from the iPhone case.
Open iPhone by swinging the display to the right side, like the cover of a book.
Next, unscrew the 4 screws on the metal panel using a Tri-Wing screwdriver and one screw
using a PH00 screwdriver.
Now you can remove the metal panel.
Disconnect the battery cable from the mainboard and 3 cables of the display.
Now you can remove the display.
To replace the display on iPhone XS, you need to disconnect the speaker with light and proximity
sensors from the original display and install it on a new display module.
Unscrew 3 screws using a Tri-Wing screwdriver.
Using hairdryers, heat the front side of the display where located the sensors.
Carefully separate the sensors from the display housing.
If this sensor is damage, the Face ID will be lost, so special care is required not to
damage one of these components during removal and replacement of the display.
In the description of this video, I left links where you can buy new display.
Install the proximity sensor and light sensor.
Install the speaker and fasten the 3 screws.
The display module assembled, now you can install the display and test how everything
works before final assembly with gluing the iPhone case.
Connect 3 cables from the display module to the mainboard and only after that connect
the battery cable.
Turn on the iPhone and let's check how everything works.
If the phone works well, the next step is final assembly with gluing.
Remove the old adhesive tape from the iPhone case.
Using medicine alcohol, wipe the surface of the iPhone housing where old tape was located.
Now, take new adhesive tape and apply to the case.
With this tape, you save waterproof resistance of your iPhone.
I left link in description where you can buy this adhesive tape.
Connect 3 cables from the display to mainboard and only after that connect battery cable
to the mainboard.
Set metal panel and fasten 5 screws.
Turn over the display and press down the display around the perimeter of surface.
Fasten two screws near the lightning port.
Now you can turn on the iPhone xs and use it.