hey guys drew with geoarm back here to talk with you about the 2gig edge the brand new panel
from 2gig and how to get it wired for power this is super easy to do this panel is also
a lot of fun to work with very very cool new piece of equipment what you're going to see first here
is the documentation itself this will explain everything that i'm going over in this video
in better detail probably than what i'm going through it in but
uh this guide is very very thorough and if you need assistance with anything you know this guide
should be able to help you out and if not you know we're always there for you as well give us a call
but what i'm going to do is i'm gonna go ahead and put this over to the side here
and uh before you get going on this you're gonna need a phillips head
a flat head and you're also gonna need a strip of 22 gauge 20 gauge or 18 gauge two conductor wire
this is to get the power supply wired in which as you can see i've already done
just to save a little bit of time the first thing you're going to notice on the 2gig
edge is that there's a screw on the bottom that holds this plate in what you're going to need to
do is just you know back out that screw a little bit it doesn't actually come all the way out it
kind of just stops there then you're just going to remove the actual the back plate itself like that
and it comes off and as you can see inside of there i've already wired it we have red going
to dc in plus and black going to dc in minus and uh the reason for that red typically represents
positive power so d c i n plus is going to be a the positive terminal and black typically
represents the ground or the negative and that's going to be for dcin negative or minus uh you can
see that i wired it through its back plate already so that way it's easy to pull it out you know and
and get it put back so uh also the battery when you plug this back up battery in you are gonna
hear a humming sound more than likely that's okay uh when you plug the power supply in that does go
away so got the battery plugged in now the power supply is wired in to the panel so we'll get the
back plate put back on and we'll get our screw put back in place to lock the back plate in
all right
all right once you do that then what you're going to do is you'll grab the actual power
supply itself which as you can see i've already wired in so the red wire that was going to dcin
plus is actually going to one run to the positive terminal that you'll see on this
power supply it's labeled positive and negative so red goes to positive from dc in plus and black
goes to negative from dcin negative so you'll see those two it's wired in so at this point we are
ready for power so we'll go ahead and plug it in and we will take a look here and get some power
okay looks like we're getting there
at this point it'll go through a booting sequence and a cycling sequence so it may
take a few moments for it to actually become fully powered and ready to go but at this moment you do
have power and you're actually ready to go ahead and move on to the next part of your system which
depending on upon what you're doing you know could be programming your user codes
getting your sensors in there whatever it may be but this is the actual panel and uh
that's how you get it wired in for power if you guys have any questions or you need anything
uh please feel free to leave us a comment below but this is the powering of the 2gig edge system
make sure to subscribe to our youtube page and click the show more tab underneath the
video where you can view valuable links pertaining to this product
similar how-to videos and our low-cost no contract alarm monitoring services