I'm Adam Powell for Geberit and today I'm going to show you how to install the
Kappa
prior to installing the system we need to work out two crucial measurements we
need the finished floor height at the point of the pan and the height of the
inlet of the back to wall pan that's been chosen we've established that the
top of this bottom plate is our finished floor height at the pan we know that
this is the center of our waste which is the center of the cistern and a crucial
measurement is 350 mm to the center of the pan chosen this mark here is our 350
mm to the center all our measurements will be taking off that point our fixing
points are then based at 335mm up from that point for our brackets for the
installation we know that that's our center of our bracket I've gone ahead
and installed the fixing noggins for our supports we need to transfer a line a
level line between the supports to ensure correct level operation of the
system we also got to transfer a plumb line from the center of the pan to the
center of the system as well in the next step we need to mark out our fixing
points at 520mm Center to Center for our brackets these are the supplied
bracket and the fixing bolt it has a 13 mm hex head in a washer we're going to
install the system the brackets slide over the top there and there now we need
to fine-tune this bracket to suit level in plumb
now we've determined the depth of the system we can now install this clip in
the bracket to lock it off the next step on the installation and it is a crucial
step there needs to be a support block behind the flush pipe now it's time to
install the water stop cock you install it from outside in and it's keyed in on
this recess here and you lock it off with the back nut from inside once
that's in you want to install the installation duct depending on which way
you put it it could be front mount which we're installing today or depending on
your installation you may require it to be vertically now to fix it off there's
six holes that need to be screwed in for on the front to either side in one on
each side at the back okay now you've installed the cap assistant before it's
sheeted you need to check for plumb and level if there's any adjustments needed
now's the time to do them and also check for water tightness before it sheet it
as well and for any more tips and tricks and product information head over to
geberit.com.au