hi I'm Mike the 1a auto we've been
selling auto parts for over 30 years
[Music]
[Applause]
hi everyone sue here at 1a auto and
today we're gonna show you how to change
your blow motor in a 2011 Ford f-150
it's located here on the passenger side
right underneath the glove box so if you
need this pot or any other part for your
car click on the link below and head on
over to 1a auto calm seven millimeter
socket and there is three trim bolts or
screws down here I'm gonna take all
three out I like to do this and leave
the glovebox latched so that way I don't
have to hold on to everything balance it
now I can hold on to this and do the
latch and just slide the glovebox out of
an angle
now there's two plastic Clips here that
hold this felt liner up I'm gonna take
those out with a body clip
it's stubborn I always find surprises
under people's glove boxes well just
move this out of the way so we can work
that to remove the blower motor there's
three mounting screws there in a
triangle form and they're at eight
millimeter socket first thing I like to
do is disconnect the electrical
connector that's that tab right there
squeeze it with your thumb pull down on
it there we go now that's out of the way
make it a little easier and then eight
millimeter socket back one here is the
trickiest one I think so after several
decisions long socket short sockets
little socket the gear ratchet works the
best I didn't think it'd work I didn't
think it would go up in there put it fit
holds up we have one left
right there I'm just gonna go right with
the gear ratchet funny when doing blow
motors sometimes you get little
surprises you take this blow mark you
know sometimes just acorns or leaves
family a mice
we lit manipulate it down here we have
the new blower motor from 1a auto it
comes with a cage it comes with a lock
clip on it and it's balanced that's a
cool thing to see sometimes you get
these parts aftermarket they're not
balanced that's a it's a quality sign of
quality here is the factory one it still
has the Ford part numbers on there that
came balanced they call this the
squirrel cage that's a press-on there's
no clip the same two prong connector so
if you need this part or any other part
for your car clink on the link in the
description and head on over to 1a auto
comm so now we're going to install the
new little motor I'm just gonna
basically try to reverse the procedure
make sure you turn it so that the
mounting bolts line up there we go
I've install the closest my Knights
group first wonderful no I can get the
other two started this is definitely a
patience game this one okay I want put
that last bonding screw in on this side
see if I can balance this out once you
get them all started just take your time
and tighten up
now that the blow motor is fully mounted
up there I'm gonna reconnect my
connector check again for any melted
harnesses it looks good line it up and
it clicks in place you're all set so
when you put the felt panel back up
you'll see this guided slot and there's
a stud that sticks out from the back and
just that's for that to go right in
there like that and now we have the body
clips push those up into the mounting
spots
grab on glovebox so to install it I just
go at an angle put those ears in there
that's the door that stops and I line up
the latch snap that and now I've got my
three mounting screws and I'll put those
in on the bottom this is the seven
millimeter socket get thee Center one
and right side than the left
well if you have any problem with the
felt that's a metal tab you can always
bend that back better visual effect
there we go
thanks for watching visit us at one
arrow comm for quality auto parts fast
and free shipping and the best customer
service in the industry