Hey everyone and welcome back to the Sawickipedia. Today we're looking at the
different error codes that may be thrown up by your Bosch, Siemens, Neff, Kenmore,
I think a couple of other different brands dishwasher. There's going to be separate
videos for each error code so I've split these up into a big playlist so you can
look at your particular error code without having to look through all the
other crap about the rest of the error codes.
I'd suggest hitting the subscribe button now just so you can easily come back to
these videos whenever you need to, it's gonna make it a lot easier to find the
the for you, but apart from that we'll get straight into it. Okay, so if you're
getting an E01, E02, E03 E04 and maybe E05 codes, these all
relate to the power control module having an issue.
All right now before we do anything else just make sure that the
power dish washer is turned off, and also the water to the dishwasher is also
turned off. If you've got an inbuilt unit you will have to remove your kick board
in order to access the bottom of the dishwasher. So in order to get the whole
machine out you first need to open up the door and just undo these two t15
screws, there's little brackets here, and then at the bottom of the machine you'll
probably need to lower the actual feet themselves. So you need a 17mm spanner
and just turn the feet counter clockwise until the unit drops down. There's also a
screw here which will take a flathead screwdriver, you also just need to turn
that counter clockwise so the rear the unit can drop down as well. And then the
other thing to do would be to disconnect your outlet hose and also the inlet hose.
And of course disconnect the machine itself from the power depending on where
your power outlet is. So to remove the power side panel first figure out which
side the actual power is running into, that'll be a power side panel, and you'll
need a Torx t15 bit which you can pick up at any local hardware store or
electronics hobbyists store. Open the front door of the dishwasher and you'll
find just behind the seal there's two Torx screws that are hidden away there
so undo those.
And once they're out you should just be able to pull the panel out towards you.
You can grab it just behind the back because there are just a couple of clips
here and here that are holding it in. So if you manage to pop it out around those
and then you should be able to just slide the panel downwards and off.
This little bit here has just come off the top, there remove that, that's just sits on
the top, and then if you can take off this insulation and sound-deadening.
And down here you've got your power panel, so you can pop this open,
there's two clips at the front. Lift that up and then pretty much just make sure
everything's plugged in properly and no wires are frayed inside. If there's no obvious
problem you can also pull this out, it will involve disconnecting all these
wires then opening it up, but I'd only do that if you are confident that you know
what you're doing.
That's about it for this video I hope it's helped you out
the only thing I'd ask in return is for you to subscribe to this channel which
you can find a link to in the bottom corner of this video, there's also
another one popping up in the top corner of your screen somewhere around now.
As always thanks for watching the Sawickipedia! Please hit the like button and
you can leave me a comment down below, as always thanks for watching,
see you later