Hi everyone, welcome back to geardo. Today we will show you how to replace
the lcd & touch screen digitizer glass on the iPad 9 Gen 2021 10.2 model,
Before Starting, we need to have the right tools to proceed with the repair,
which You can find in the description.
Proper heating is required to separate the screen from the body for tablet repair.
For this, we use a heating pad designed for tablets and mobile phones. On the iPad 2021,
make sure to heat the front side. Select the Tablet heating option and leave it till
the heating completes. Alternatively, you can use a heat gun or hairdryer.
Once the heating has completed, use a suction cup on the sides to lift the front screen. In
between, Insert a Plastic Card pry tool or triangle picker and cut the adhesive around.
Be gentle while pulling; there are flex cables attached to the logic board.
To lift the touch screen, take the direction like opening a book,
but from the left-hand to the right-hand side.
Open and place it like an open book till removing the LCD Screen.
Next, take off the LCD screen by undoing screws; there are sticky tapes are covering
the screw heads; move aside and remove four screws. Next, lift the screen to 90 degrees
by the top and disconnect the plug by undoing three screws and the shield.
Next, unplug both touch screen connectors by the socket,
peel the tape, and raise the tab to take the touch ID connector plug.
Now the Touch Screen unit can leave from the body.
Assume you have a broken Touch Screen; there are two parts available,
one is the Touch screen digitizer assembly, and the other is just the touch screen digitizer.
The difference is digitizer assembly comes with
the home button & flex while digitizer is coming without the home button & flex.
If you choose without the home button & flex, then you need to extract the
home button and flex from the broken screen and place it on the new unit.
First, apply little heat to soften the glue on the button and then gently peel the cable
using a pry tool. Make sure to push the button slightly from the front side.
Next, take out the button flex and place it on the new screen.
Next, place the touch screen in the body by connecting both
touch screen connectors and the Home button flex.
Next, Place the New lcd screen and secure the
connector. And then add the shield by inserting screws.
Next, insert four screws and secure the screen.
Next, to clamp up the iPad 9, first ensure it has enough glue on it.
If not, you can use B7000 glue or Double-sided pre-cut adhesives.
Take the closing book direction and place the digitizer on the body. Place the bottom
section first, then follow the top, and then simultaneously click sides and the bottom. Make
sure to put pressure on the frame sides and verify that the home button sits and clicks precisely.
Here, we are using screen bonding clips to tighten the screen to the frame.
If not, you can use rubber bands and leave them for some time.
hope you have enjoyed the Replacement guide
Let us know if you have any questions; please like, share, and comment on our videos.
Do not forget to hit the subscribe button.