Hi. This is Matt at Agilent Technologies. Today we will be discussing how to
install an N6781A SMU module into an N6705A DC Power Analyzer.
So the first thing we’re going to do is take the cover off so let’s get to that.
So to remove the cover you just take these two thumb screws back here, you unscrew them,
and then you push the cover back a little bit and lift it up and just put it on the side.
The other thing you need to do is get the connector and the adapter that came with
your N6781A module, and to line it up correctly, there is this little ridged edge on the bottom
of the adapter. You want that on the bottom, and the screws are on the top of the connector.
So you take that and align the bottom hole on the connector side with the bottom prong
on the adapter side, and just insert the adapter into the connector like that,
and then you take a small flathead screwdriver and just tighten all the screws.
So now you’re just going to take the module. There are holes in the middle of the module
that you want to line up with the posts in the mainframe meter. So just take it, line
them up and line the back up with the air deflector, and when it’s all lined up, it
will slide down easily, and then you just want to press lightly here to get it
to install onto the connector.
Next you just want to take the adaptor that we put together and plug it into the connector
on the back of the unit. So that goes in, and now we’re going to screw the module
into the mainframe. So we’re going to take a T-10 tip, Torx head, and take our screw
that came with the module and put it in the hole here and just screw it in.
Make sure it’s lined up, and now there’s another screw on the front to secure the module
inside so we’ll screw that one in, too. You don’t want to do it too tight, but
just so it keeps the module in.
And we’re just going to want to take our channel one connector here
and plug it into the adapter.
And use our small flathead to screw it into the adapter like so.
Then tuck our cable underneath our air deflectors so that it doesn’t stick out the side.
And lastly, we’re going to put the top cover back on, place it over, get the little lips
underneath the side, push it forward a little bit, and then screw it in.
Now it’s on and ready to turn on.
So that’s how you install the N6781A module into the N6705A DC Power Analyzer.
If you have any questions about either of these products or any other Agilent products,
please contact us through the Agilent website at agilent.com.
Thanks for watching. This has been Matt. Bye.