All hi friends. Today I will show installation of the Xentry 2021 program.
It is not cut down version namely the official version of Daimler.
Also I on the channel have an installation of the Xentry 2016, 2018, 2020 program.
Also on the channel there is an installation of the program WIS/EPC, DTS Monaco, Vediamo through Openport and Mini Vci
All these programs work through Openport. All references in descriptions under video.
I will leave the reference to Openport in descriptions too.
We open the panel management + Accounts of users + to Change control parameter accounts.
We lower the slider most down and we press OK
We open the folder which you downloaded at me.
I show that we establish on Windows 10 X64, and on disk C before installation freely 133 GB.
At the end we will look how many the place was taken by the Xentry 2021 program
In the XPT folder 2021.3.3 we press the Start file and we start on behalf of the administrator.
We choose language which is necessary to us.
Ok + to Establish
Choose I the client from USA/Canada + Further + Further + Further + to Establish
We press it is ready and we reboot.
After reset the Config Assist window opens, simply we close a window.
We copy these two folders.
We insert + here we Press to replace
Again we copy these two folders.
We insert here
We start this file for 64 bits + OK
We copy the XS folder and we insert into disk C.
We open the XS folder and we start the Install file + the Gap
We press a configuration + Further + Further
We press Export and to keep on a desktop
We copy ID and we insert here. We write 2021 and for example 2035
We press to receive the code and we copy a long key
In ConfigAssist we press in manual and to insert + to Keep + OK + to Apply and continue
We press without Retail Data Storage + OK
There is a start of XUS.
We were already connected to the server. Here green tick + Further
We wait for check of availability of servers. Here, servers are available.
We close ConfigAssist
We copy the program for ignition on a desktop
We install the driver for Openport
We come into a device manager and we connect Openport.
The right click + to update the driver + we choose a driver installation site
We choose Openport or other your device.
Also we will solve problem 2221 now.
We copy this line and we insert into search in disk C.
We see two similar files which are in Program File (X86). We delete these two files.
Simply we close a window of registration.
I will show how to make that a window of registration I didn't appear any more in the following video.
If you at updates of Add-ons have here such mistake.
The reference to video with the solution of this problem, in descriptions under video.
Or here on the right top corner the hint appears.
And who has no mistake just continue to establish Add-ons.
Installation of Add-ons takes about 2 - 2.5 hours.
It is necessary to reboot for continuations of installation of add-ons
We reboot and proceeds installation of add-ons.
Updating isn't found. We close Addon Center.
That is for full installation of the Xentry 2021 program with Add-ons it is necessary to 76 GB the place in disk C.
Even after installation of the Xentry program, it is possible to change language.
System installations + the General + Installation of language (For example we put English)
Also let's check XUS (Xentry Update Service)
At online coding it is obligatory. StartKey is valid
At the end I will show that the program works through Openport.
Mercedes E Class W212 car, 2014.
If at you the button to apply it isn't active, then from below change this line.
Subscribe to the channel, put like.
If the program is necessary write in comments.
All thanks and good luck on roads.