Check to ensure all cables are properly connected
Insert a microSD card into the intelligent controller
Adjust the antennas to make them stand vertically
Install the intelligent battery
Please make sure you have charged the battery before using it for the first time
Press and hold the power button for about two seconds to turn it on
Open the RoboMaster app
Sign up for a DJI account or log in using your existing account if you have one already
Then follow the instructions to connect the S1 to the RoboMaster app
Before activating the S1
make sure your mobile device can connect to the internet
Enter the Online Activation page
Please read the Terms of Use carefully
During activation
the S1's hardware information needs to be uploaded
After verification is complete
reconnect your mobile device to the S1's Wi-Fi to finish activation
Lift up the chassis
Start by addressing the chassis' four motors
Then the S1 can move normally
Rotate the right front Mecanum wheel manually until the S1 makes a beeping sound
Then rotate the left front wheel
left rear wheel
and right rear wheel to address the remaining motors
When you're finished
tap the onscreen icons to check whether all Mecanum wheels can rotate normally
If the Mecanum wheels do not function properly or the addressing is incorrect
please reset and try again
Next we'll need to address the S1's armors
This will ensure the armor plates can detect hits
Lightly strike the center of the rear armor plate to begin addressing
If the strike is registered successfully
the LED light will glow solid blue
After that
hit the front armor
left armor and right armor
Skip the armor if it does not respond to hits
Go to "Settings"
"Robot" and then you will see the current device's status
Tap "SOLO" to enter FPV screen
You can make the S1 move forward
backward
to the left and right via the virtual joystick on the left side of the screen
The speed and acceleration can be set in the "Settings"-"Control" menu
Press and hold any free space on the right side of the FPV page to control the gimbal
You can also go to the "Settings"-"Control" menu to enable the “Gimbal Gyro Control” function
Chassis and gimbal sensitivity settings can be customized in the "Settings"-"Control" menu
Aim at a target and tap the launch icon to shoot infrared beams
The default firing mode uses infrared beams
but users can change the firing mode to gel beads in the "Settings"-"Control" menu
To improve aiming
tap the target icon on the bottom right of the screen
The image shown on the screen will be magnified four times
Tap the video or camera icon to record a video or take a photo
After enabling the S1's voice transmission function
you can listen to real-time audio from the S1's microphone through the app