Required tools: Wire brush WD-40 spray All-purpose cleaning spray Brake cleaner Copper grease
Drive socket # 14 Combination spanner #14 Combination spanner #17 Wheel impact socket #21 Ratchet wrench
Torque wrench Tap wrench Rubber mallet Water pump pliers Flat Screwdriver Crow bar Hub slide hammer puller Wheel chock
1. Raise the rear of the car and secure on supports.
2. Unscrew the wheel bolts. Use wheel impact socket #21.
AUTODOC recommends: To avoid injury, hold up the wheel when unscrewing the bolts.
3. Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
4. Detach the parking brake cable from the bracket on the brake caliper. Use water pump pliers.
5. Unscrew the brake caliper fastening. Use a combination spanner #14. Use a combination spanner #17.
6. Spread the brake pads. Use a crowbar.
7. Remove the brake caliper.
8. Remove the brake pads.
9. Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
10. Unscrew the caliper bracket fastening. Use a drive socket #14.
Use a tap wrench. Use a ratchet wrench.
11. Remove the caliper bracket
12. Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray.
13. Remove the brake disc. Use a rubber mallet.
14. Clean the wheel hub fastener. Use a wire brush. Use WD-40 spray.
15. Clean the ABS sensor connector. Use all-purpose cleaning spray.
16. Detach the ABS sensor connector. Use a flat screwdriver.
17. Disconnect the ABS sensor wiring.
18. Unscrew the hub bearing mounting. Use a drive socket #14.
Use a ratchet wrench. Use a tap wrench.
19. Remove the hub and the bearing together, since they are a sealed unit.
Use the hub slide hammer puller.
20. Clean the hub bearing mounting seat. Use a wire brush.
21. Install the new wheel hub with a bearing.
22. Tighten the fastener of the wheel hub bearing. Use a drive socket #14.
Use a torque wrench. Tighten it to 75 nm torque.
23. Treat the fasteners of the wheel hub bearing. Use copper grease.
24. Connect the ABS sensor wiring.
25. Attach the ABS sensor connector.
26. Treat the hub where it contacts the brake disk. Use copper grease.
27. Install the brake disc.
28. Install the brake caliper bracket.
29. Tighten the brake caliper bracket. Use a drive socket #14.
Use a torque wrench. Tighten it to 55 nm torque.
30. Clean the brake caliper bracket from dirt and dust.
Use a wire brush. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
31. Install the brake pads.
32. Install the brake caliper and fix it. Use a combination spanner #17.
Use a drive socket #14. Use a torque wrench. Tighten it to 35 Nm torque.
33. Install the parking brake cable into the brake caliper bracket.
34. Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
35. Clean the brake disk surface. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
36. Screw in the wheel bolts. Use wheel impact socket #21.
AUTODOC recommends: To avoid injury, hold up the wheel when screwing in the fastening bolts.
37. Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #21.
Use a torque wrench. Tighten it to 120 nm torque.