Push the end cap up fully and pull the brush bar out of the cleaner head.
Remove the end cap but don't wash it.
Hold the brush bar under tap water and gently rub to remove any lint or dirt.
Remove as much excess water as possible.
Stand the brush bar upright and leave for at least 24 hours to dry.
Make sure your brush bar is completely dry before refitting.
Reattach the end cap.
Using a clean dry cloth, clean the head and then the laser.
Take care to align the end cap correctly. Position at a 45 degree angle, otherwise it cannot be pushed down into place.
Hold a lint-free cloth under water to dampen.
Wring the cloth to remove excess water.
Wipe your Hair screw tool, Light pipe crevice tool and cleaner heads with a damp cloth. Take care not to wipe the connector end.
Make sure all tools are completely dry before using.
Wipe all other tools with a damp cloth only.
Make sure all tools are completely dry before using.
Before washing your filter, tap it gently to remove any excess dust and debris.
Wash the outside of the filter, rubbing with your fingers to remove the dirt.
Place your hand over one end of the filter and then fill the other with water.
Place your hands over both ends and shake.
Repeat these steps until the water runs clear.
Firmly shake the filter to remove any excess water,
and leave for at least 24 hours to dry, in a warm place with plenty of airflow.
Check the filter is completely dry before refitting, or it could damage the motor.
Hold your machine over a bin and push the red bin-release lever.
Make sure you don't pull the trigger when emptying the bin.
To clean the bin, press the square, red release button and slide off its runner.
Wipe the bin clean with a damp cloth only.
Make sure the bin and seals are completely dry before refitting.
To refit the bin, slide it back onto its runner.
Push until the bin and lid click into place.