In this video,
we will show you how to use the DJI Motion Controller
and enjoy a flight experience unlike anything else
The USB-C port at the bottom of the motion controller can be used to charge the device
and connect to a computer for firmware updates
The Power button is on the right side of the device
Press once to check the battery level
Press once and then hold for two seconds to power the device on or off
The Accelerator is located on the outward-facing side of the device
Press the Accelerator to move the aircraft forward
Apply more pressure to fly faster
Release the Accelerator to stop flying forward
On the user-facing side of the device,
you’ll find the Lock button,
Brake button,
and the Mode button
Use the Lock button to make the aircraft takeoff or land
Use the Brake button to activate the emergency brake and hover feature
or to make the aircraft return to the Home Point
Press the Mode button once to switch between modes
On the left side of the device,
you’ll find the Gimbal Tilt Slider and the Shutter/Record button
Adjust the Gimbal Tilt Slider to control gimbal tilt
Press the Shutter/Record button once to take a photo or to start or stop recording a video
Press and hold the Shutter/Record button to switch between photo and video mode
Press and hold the power button of the aircraft until the battery level indicators blink in sequence
Press and hold the power button of the motion controller until it beeps continually
and the battery level indicators blink in sequence
The motion controller stops beeping when linking is successful
and both the battery level indicators turn solid and display the battery level
Connect the USB-C port of the goggles to your mobile device,
open the DJI Fly app,
and follow the prompts to activate
If the motion controller is not using the latest version,
there will be a prompt on the top left corner of the DJI Fly home page for a firmware update
Tap the prompt to update to the latest firmware
Before you fly,
be sure to place the aircraft in an open, unobstructed location
Check the goggles interface to make sure there are no warning prompts
and that GPS signal is adequate
Press the Lock button twice to start the aircraft motors
Press the Lock button and hold,
and the aircraft will take off automatically
and hover approximately one meter above the ground
press the Accelerator to control the drone to fly towards the circle seen on the goggles interface
Tilt the device up or down,
and the circle in the center of the goggles screen will move up or down accordingly
Press the Accelerator and the drone will fly towards the location indicated by the circle
To ascend or descend vertically,
control the circle on the screen to move up or down until it changes color
Once circle color has changed, press the Accelerator
and the drone will fly up or down vertically
If you want to make a turn,
rotate your wrist and forearm to move the circle on the screen to the left or right
The drone will rotate in the same direction as the motion controller does
You can also hold the motion controller
and tilt your forearm to the left or right to make a turn
Press the Accelerator and the drone will fly towards the circle
Tilt the device while pressing, and the drone will make a turn
To make a quick turn,
turn the motion controller quickly 180°
and the drone will do the same
Press and hold the Brake button on the device
The drone will automatically enter Smart RTH
When the drone is returning to the Home Point
please pay attention to any real-time changes of the Home Point location
Make sure your surroundings are safe for landing in advance
Due to the limited precision of GPS positioning,
there may be a slight difference between the Home Point and actual landing location