Hi, I'm Mike from 1A Auto.
We've been selling auto parts for over 30 years.
In this video, we'll be removing and reinstalling an ignition cylinder in the 2009 Chevy Suburban.
If you need parts for your vehicle, click the link in the description and head over
to 1aauto.com.
We're going to disconnect the battery.
going to use a 10 millimeter wrench.
We're going to disconnect the negative post on the battery.
Just loosen this up a little bit.
You can grab it, wiggle it back and forth.
We can take it and tuck it out of the way.
We'll take this off, just grab it and pull.
I'm going to grab this cover, going to have two fingers over here, pull down.
Grab over here with the other hand and kinda slide it out.
If you struggle taking this out or installing it, you can remove this.
I'm just going to move the steering wheel down, so I'm going to push on that lever.
Make sure be careful of your fingers, and then slide it down like that.
I'm going to grab the top part.
Two fingers and grab over there and slide that out.
We're going to use a blunt pick that we had modified.
We cut it off.
You can use a regular pick for this also.
We're going to take my key, going to turn it like I'm cranking the engine, then I'm
going to push this down here and that's going to release it.
And then I can wiggle this out and this will come out completely.
We're going to reinstall this lock cylinder.
You wanna line this tab up right here, this little key way.
You wanna make sure the key's in there and then you can turn it to the off position and
pull it up.
We're going to reconnect our battery.
Grab the negative cable.
We're going to hook it back up.
Now I'm going to use my 10 millimeter wrench and tighten down the nut, not too tight.
You don't wanna break the terminal.
Tight it and check it, make sure it doesn't wiggle.
Seems good.
Before we put the covers back on, I reconnected the battery.
I'm going to just test it and make sure everything works and the vehicle starts and stuff.
So, here we go, I'm going to start the car.
We wanna check on the dash and make sure there's no affect light or anything.
And it looks like it's working properly.
Now we're going to put this upper cover on.
going to line this up with the rubber boot over here, try to get that on.
Sometimes it's a little tricky.
Slide that in and slide the cover over here, have it lined up and just push it down.
And that's good.
Now we're going to adjust our steering wheel up.
going to slide the lower cover to the back and try to slide the boot onto the cover where
it goes in the U. And then slide the cover up.
And just click it in place.
It's all locked in.
We're going to reinstall the steering column adjuster lever, just push it in.
And you can adjust your steering wheel accordingly.
Thanks for watching.
Visit us at 1aauto.com for quality auto parts, fast and free shipping and the best customer
service in the industry.