Hi everyone welcome to my video
Today I am starting an ultimate workbench build
and hopefully we're going to solve this situation with my tools spread everywhere
Part one is gonna be the frame build so let's crack into it
Alright the frame is complete so let's have a closer look and you can see what my plan is here
So as you can probably see all of the vertical joints here, here are mortise and tenon
I would have used a few more of these for some of the horizontal ones like these
but I was kind of planning it on the fly so I had to use biscuit joints in these and then on
the inside I've used pocket holes but they'll be hidden anyway so there's no worries there
All of the stretchers up here, these are all pocket holes underneath and pocket holes on top
I also started to run out of ply a little bit towards the end so I had to start cross-cutting
and as you can see it made a bit of a mess I was also too lazy to go and get my zero clearance
plate to put that in but this is not really an issue because i'm going to cover over a lot
of these and the exposed ones will be rounded over anyway so all of that will be cleaned up
So down this end we have an assembly area,
I was originally going to go with an MFT style tabletop which is why there's a step down there
I've decided to go down a different route and use the Match Fit system by MicroJig for everything
on this table so that step down is no longer needed but I've got a good idea for some extra
storage space that that'll get used for so look out for that in the next part probably
In the middle here is going to be the miter saw
It is going to fold down so I have to build out some structure in the middle here to
accompany the hinge and that set up
and down over here the table saw is going to sit in this corner
also have to build out some structure through here to house all of that and make it stable
So around this side we're going to have
router set up about here that will depend on how far back the miter saw comes
and everything else under here, all around here, around here
is going to be storage and hopefully somewhere to put on the dust extraction and my compressor
So all of that's going to happen in my next few videos so hit that subscribe
button so that you don't miss out and if you liked this video give it a thumbs up