Welcome to the Atlas Copco Micro Torque tutorial series
In this video we will be going over how to use the auto-set function on your MT Focus controller
to quickly setup a Pset and do some rundowns on some tiny little screws on this hard drive right here
The first thing we are going to want to do is turn on our controller
We will do that by holding the button for a half second
Once the tool initiates we'll be at our main screen
At this screen I'll hit the down button
Go to select Pset
and I'll select Pset number 4 since I don't have anything recorded on that Pset
Then I'll hit the down button again
scroll down two times to auto-set and hit the OK button
Here we set our target torque, I want to go for 100 cNm so I'll scroll down by holding the button until we get there
Then I'll hit OK
Now it asks do we want to use this auto-set in Pset number 4, I'll hit yes
Now we see an indicator saying 1 of 3 so we will have to perform 3 rundowns to calibrate our Pset
After the 3rd rundown we get the notification that the auto-set is finished
It gives us 2 options, we can either hit down to adjust it or we can hit OK to continue
It noticed that the joint we were doing were hard joints
and it gave us a recommended speed of 581 RPM
I'm going to hit down
and now it gives us the option to adjust our RPM
I'll set it to 550
Hit OK to continue
and here we can set a minimum angle
a maximum angle
and a trigger torque for angle counting
by hitting OK we will now commit that Pset to number 4
and we are ready to rundown all of our joints
Before we do that..
I want to set a batch number since we are going to be doing 6 screws
so by hitting up or down on the keypad we can go down to batch control
hit OK
and then scroll down to set size
I'll increase this number to 6
hit OK
and now we have 0 of 6 up top
I'm going to go ahead and loosen those screws that we used for our auto-set
and now I will run down the 6 joints for this batch
We got the green Okay
green OK
and on our final screw
The screen should turn blue to let us know that the batch is OK
and there it is
And that is how easy it is to setup a Pset using the auto set function
you don't need to use a computer or ToolsTalk MT software, you can do it all directly on the controller
I hope you enjoyed this video, if you have any questions leave the in the comments below
thank you for watching
and be sure to subscribe to Flexible Assembly
for more product news and tutorials in the future.