We've designed the DUAL TEC DT8000 series to offer you
an easy and fast installation.
To install these sensors in a home or business,
all you need is the following-- your hands,
a flat blade screwdriver, and an electric drill with a Phillips
bit.
First, open the sensor.
To do this, firmly hold the backplate, press in the tab,
and separate the two halves.
To begin wiring, open the entry port
with a twist of a screwdriver.
Pull your wire through the wire entry port.
You are now ready to mount the backplate to the wall.
To save you time, the mounting screws
are already nested in the backplate.
There's no more looking for loose screws.
Take out one screw and insert the screw
into the collar to make it easier
to mount the unit with one hand.
The collar grasps the screw firmly in place, hands free.
After installing the first screw,
it is recommended to attach the second screw
into the tamper plate collar as shown.
The breakaway rear tamper plate must
be mounted to a stud, solid wood,
or with a firm wall anchor supplied with the sensor.
You have two options to attach the wires--
either directly to the terminal block
attached to the backplate, or you
can remove the terminal block.
Here's how.
Place two fingers over the tabs on either side of the terminal
block.
Firmly pull down on the tabs, then pull the terminal block
away from the tabs using the thumb of your other hand.
Wire the terminal block as shown on the wiring
information in the installation instructions.
Push the excess wire back into place
and snap the terminal block onto the backplate.
Now you can pick up the main sensor housing
to make adjustments to the sensor as needed.
You can adjust the motion sensor to look down
by simply turning the look down adjustment clockwise
until the arrow points to the on position.
For DUAL TEC sensors, adjust the microwave
from minimum to maximum sensitivity
by turning clockwise for maximum or counterclockwise
for minimum.
There are two dip switches, one for turning the LED on or off
and one for turning the pet immunity on or off.
It is important to note that when pet immunity is turned on,
always make sure that the look down zone is turned off.
For the Mirror Optic's DT8050A and IS3050A,
you can disable the motion sensor look down
by pulling the tab towards you.
Adjust the microwave sensitivity from minimum to maximum
by turning clockwise for maximum or counterclockwise
for minimum.
You can adjust the end of line resistor
by sliding the appropriate dip switch to the on position.
Set value by the type of control panel you're using.
There are two dip switches-- one for turning
the anti-mask feature on or off and one
for turning the LED on or off.
To provide strain relief to the wire harness,
it is recommended that you attach the cable tie
wrap included with each sensor.
Now take the sensor housing and align the tabs on top
and snap the cover in place.
The LED will begin to flash slowly for about 30 seconds
during warm up.
When the detector is initialized and ready for walk testing,
the LED will stop flashing.
You are now ready to walk test the pattern
and make any necessary adjustments.
Walk test period will automatically
time out in 10 minutes.
You have the option of locking the cover
to avoid tampering by turning the lock
clockwise with a screwdriver.
If the walk test mode is timed out,
you can easily re-enable the walk test mode
by standing four feet or less from the sensor
and waving a flashlight beam over the lens four times.
The LED indicator should start blinking, allowing
you to start the walk test period over again.
We hope our installer friendly features and this how-to video
have helped you complete this installation in a snap.
If you need further assistance, please review the installation
instructions.
Visit Honeywell's online support at mywebtech.
Or call the Honeywell support line at 800-323-4576.
[MUSIC PLAYING]