Hi everyone, Welcome back to geardo,
Today we will show you how to replace the lcd screen display on the Motorola Moto G8
Power 2020 mobile phone.
To start, we need to have the right tools to proceed with the repair, which You can
find in the description.
First, turn off the phone, take out the sim tray, and follows with the back cover removal.
To remove the back cover, it needs to heat gently around the back cover edges until the
pasted adhesive becomes soft.
For this, we are using a heating pad.
Place the back cover side on the heating pad and Select the mobile phone HEATING option
and leave it till it completes.
Alternatively, you can use a heat gun or hairdryer.
Next, create an opening using a suction cup and then insert a plastic card pry tool or
something similar to cut the adhesive around the back cover.
Next, using a heat gun, apply heat to soften the glue on the fingerprint button.
Next, Hold the touch id button and pull out the back cover from the body.
Next, Take out
the board frame by undoing Nine screws.
Be gentle with the fingerprint button.
Next, disconnect the battery plug by releasing the graphite tape.
Next, release the black tape on the bottom of the battery.
Next, apply some heat to pull out the not working battery from the body.
Next, gently using a pry tool, cut the adhesive under the battery.
Sometimes you will need extra heat to soften the adhesive under the battery.
If not, gently use a pry tool to cut the glue.
Next, pull out the logic board by undoing the screw, ejecting the sim tray, and disconnecting
the lcd plug, main ribbon plug, and two antenna heads from the board.
Gently lift the board using a pry tool while releasing the front camera.
Next, apply some heat and pull out the vibrator motor and earpiece unit from the body.
Next, take out
the speaker cover by undoing five screws and releasing
the tape.
Next, peel both antenna cables and main flex cables from the body.
While prying the main flex, be gentle; an adhesive strip holds the cable and releases
it to pull out the charging board from
the body.
The only remaining part is the broken front screen assembly with the frame.
There are a few different screen types for the replacement in the market.
The most common is the Original service pack screen, which comes with the frame and buttons.
There is another type; it is original but without the frame.
But the repair job is a bit difficult and time-consuming, and the price difference is
not that big.
And also, there are refurbished, used, aftermarket screens with the frame and without.
I recommend you go with a screen with the frame & buttons installed.
It can be original, refurbished, used, or aftermarket.
And this type is commonly available to purchase.
Next, on the new screen frame, start placing removed parts.
First, place the vibrator motor on the body.
Next, secure the earpiece.
Next, place and secure the logic board in the body and secure the screw and the sim
tray.
Next, place and secure the charging board with the main ribbon flex.
Ensure the antenna placement in the frame and secure the adhesive strip on edge.
Connect the antenna heads and place the speaker cover by adding five screws.
Next, place the battery with adhesive.
Next, secure the battery connector and place the tape.
Next, place the board frame by adding nine screws.
Ensure the fingerprint button is secured.
Next, Before installing the main back cover, make sure it has enough glue.
If not, use B7000 glue or a new double-sided back cover adhesive.
Finally, we are adding bonding clips to tighten the rear cover with the body.
If not, you can use some rubber bands and Leave them for some time.
I hope you have enjoyed the replacement guide.
Let us know if you have any questions; please like, share, and comment on our videos.
DO not forget to hit the subscribe button.