The Only Screen Protector you should consider for your OnePlus 7 Pro
Welcome everyone I’m Tech Zilla & today I will be installing & Reviewing the Whitestone
Dome glass screen protector for the OnePlus 7 Pro.
What you get in the package is the installation tray, 2 tubes of glue, a small packet containing
the dust removal stickers, microfiber clothes, side pads & a plastic key, a couple of earpiece
stickers, the glass screen protector, a UV lamp and cable and finally some instructions.
To start with remove the awful plastic screen protector that comes pre-applied, now give
the screen a good wipe with one of the alcohol wipes to remove any fingerprint grease and
dirt which will prepare the screen for a good bonding surface. Next simply use one of the
included microfiber clothes to dry the screen off and remove any residual marks left from
the previous stage.
You now have to place the OnePlus 7 Pro in the tray and apply the earpiece sticker which
is to prevent any glue seeping into the grill and speaker. Once done take the top part of
the installation tray and insert the side absorption pads to soak up any glue that escapes
from the edges of the screen protector. Lastly use a dust removal sticker to remove any lint
or dust that may have settled on the screen.
Its glue time next, place the bridge over the screen in the appropriate groves and place
a tube of glue into the top and leave the glue to poor out onto the screen, once the
tube is empty remove the entire bridge with the tube still installed. Insert the plastic
key into the top of the tray and prepare the screen protector by removing the backing and
gently place it over the screen of your oneplus 7 pro with the top part resting on the key.
Now the tricky part, push down on the bottom of the tray slowly and steadily, so the glue
starts to move to the centre of the screen, once it makes contact with the screen protector
quickly pull the plastic key out and let the glue spread evenly across the entire screen
so no gaps are left between the screen and the protector which should take around 80
seconds but be patient and do not touch the tray or screen at this point.
We are nearly there, now using the UV lamp use it to cure the glue on the top half of
the screen for 15 seconds only, do not go beyond this time, repeat this step with the
bottom half of the screen again for 15 seconds.
Finally we can remove the OnePlus 7 Pro from the tray and using one of the alcohol wipes
remove any glue that might have seeped out on the edges but be gentle. The last stage
is using the UV lamp again cure the glue for a full 1 minute on the top half of the screen
and repeat for another minute on the bottom half.
That’s it we are done, as you can see the screen protector fits perfectly around the
edges with very little gap but enough to be able to use the Ringke Fusion case, This glass
coating is smooth much better than the plastic and it feels nice to use and swipe, the fingerprint
sensor works just as well as if I was using the bare screen and over all the best choice
for anyone with a OnePlus 7 Pro, If you liked the video smash the subscribe button and bell
notification icon as I will be reviewing loads more accessories for the OnePlus 7 and Oneplus
7 Pro, this is Tech Zilla saying take care and peace.