Today we're showing you how to properly assemble and install the SC400-V2 Mobility Carrier
Parts needed for assembly include Carrier, Folding Hitch Tube, Ramp Bracket, Pull Pin
& Clip, Spring Pull Pins, Ramp Bracket Bolts & Lock Nuts, Carrier Bolts & Jam Nuts
Parts needed for step 1 include Carrier and Spring Pull Pin
To begin, install the Spring Pull Pin into the front of the carrier basket.
Adjust Spring Pull Pin with enough room that when pulled back, the ramp can be lifted out
of the carrier basket.
Secure in place using Jam Nut
Parts needed for step 2 include Folding Hitch Tube, Pull Pin & clip, Carrier Bolts & Jam
Nuts
With the carrier flipped upside down, slide the Folding Hitch Tube into the center support
tube on the carrier.
Align the pin holes and insert Pull Pin.
Secure with Clip
Install Carrier Bolts and tighten firmly.
Screw the attached Jam Nuts onto the tube and tighten firmly.
Parts needed for step 3 include Spring Pull Pins, Ramp Bracket, Ramp Bracket Bolts & Lock
Nuts
With the carrier right side up, install the Ramp Bracket to the carrier using Ramp Bracket
Bolts & Lock Nuts.
Tighten firmly
Next, screw the Spring Pull Pins into place.
Please note: If the Spring Pull Pins do not line up, loosen the Ramp Bracket bolts to
position the pins properly
Spring Pull Pins may also need to be adjusted in and out to work properly with the loading
ramp.
Once properly adjusted, secure the Spring Pull Pins in place using Jam Nuts.
Parts needed for Installation include Pinch Bolt and/or Anti-Tilt Locking Device and Hitch
Pin
Slide the Anti-Tilt Locking Device onto the carrier hitch tube, with the 3 bolt side facing
the hitch.
Now, install hitch pin and slide the Anti-Tilt Locking Device tight up against the hitch
receiver.
Fully tighten all bolts.
The Pinch Bolt can also be used to secure the carrier to your vehicle.
Align the 1/2” hole on the hitch tube with the 5/8” hole on your vehicles hitch.
Next, Insert the bolt into the metal sleeve and slide the Pinch Bolt into the 5/8” hole
and fully tighten.
The Anti-Tilt and Pinch Bolt were designed to help reduce carrier wobble during transport
To help eliminate the Folding Hitch Tube wobble, tighten the Hex Head Pivot Bolt.
Do not over tighten.
If overtightened the carrier will not be able to pivot or swing up.
The SC400-V2 can be folded upright to save space when not use.
Before folding, remove the pull pin.
The pull pin should be able to be removed or installed without binding if properly adjusted.
To remove the pull pin lift up on the front of the carrier and pull out pin.
To adjust the folding hitch tube, tighten or loosen the adjustment bolts.
Once pin hole are aligned install pull pin and fully tighten Jam Nuts.
Remove the Pull Pin to fold the carrier upright.
Replace Pull Pin in the top hole to secure the carrier in the vertical position.
Thank you for watching this demonstration video on how to properly assemble and install
the SC400-V2 Mobility Carrier