welcome to wacky Wednesday's where everyone has a chance to show off their
car mods, and here's this week's winner,
hey Scotty thanks for the chance to let me show off my 1996 Ford Bronco, let me
show you around, so when this Bronco was new in 1996, it was a government vehicle
driven by an OSHA inspector and I'd say that OSHA inspector is probably the
coolest guy on the job site, the biggest modification I made to my truck is a
six-inch suspension lift and some 35 inch Mickey Thompson tires, I also
installed some worn locking hubs, so here's a picture of my Bronco when
I first got it, I've spent countless hours on it to get it to where I want it
to be, I did paint the top because of all the exposed fiberglass, but the body
paint is all original and as you can see it is pristine, the engine is a stock
Windsor 351 v8 and behind that is a e4od 4-speed automatic transmission, I design
and fabricated this rear bumper, it's got reverse lights, d-rings, trailer hitch and
a full-size 35 inch tire that is on a swivel, which I can open up and once you
open this up, locks right there, and then you can come over here and with the key
can roll down the rear window and reach in here grab the handle and the tailgate
is assisted as so it doesn't break the glass window that's on the inside and in
this cargo area you have two pockets, I added a light switch here and that turns
on some LEDs, that will light up this rear area for when I take the rear seat out
and put a bed back here for camping, so this Bronco is full of many modern
amenities, you have a am/fm radio, no cassette no CD, simpler I have AC blows
cold, you have crank windows, manual locks, wing windows
that's luxury, and if you and your friends are on the cigarettes hard
you have three ashtrays, and down here I put a switch which turns on some lights
and this being in 96, it's the only year of the Bronco with obd2 and of course
have the CB for talking on the trails
something I'm not too happy about is the center console, I had to add this divider
here because anything you put in here slides forward and doesn't allow you to
put your beverage into the cup holder, I also don't like this pocket because if
you put stuff in there and close it, just falls out, I wired up a switch and two
12-inch light bars they are phenomenal, future plans for this truck are to do a
solid axle and a manual swap, if you want updates on that you can follow my
instagram at ccc 4x4, thanks for watching,
well that was this week's video and to have your car mod shown on my channel
here, check this out, so if you never want to miss another one of my new car repair
videos, remember to ring that Bell!