Welcome back to Albany County Fasteners - Fasteners 101. I'm Bob and today,
We're going to unbox these organizers and I'm going to show you how to install them. So let's get started.
So I have this two-tier under sink organizer.
Under that sink over there, which I'll show you, is totally disorganized. So we're going to get it organized.
This new unit I bought at The Container Store.
It's made of some great heavy gauge steel. Directions, some screws...
These are some legs or extenders that we're going to have to install.
All right. So those extenders go...
right in here. Depending on what side. So this is reversible:
you can put this on the left side or on the right side, you get the choice. It's a matter of just turning it around.
I'm gonna cut these zip ties off that they have holding it in place.
These are smooth gliding tracks.
So there's a long side and a short side that are depressed.
Long side obviously goes down. The short side will go on this side here.
There we go. Awesome. I have some screws here and I'm gonna screw it down in the cabinet.
All right, let's go to the cabinet.
So you can see this is all cleared out.
I took everything out of here. I have my screws here that I'm gonna be using to install this.
I'm gonna slide this in and I'm gonna place it there.
Wherever you place it you want to make sure that you're not gonna interfere with anything.
You don't want to interfere with any pipes, you don't want to put any screws through any pipes.
So you want to make sure you're...
...you're not gonna puncture anything when you drive those screws in.
As you can see here I have some wires and I can close the door just fine.
It's going to slide in and out perfect once I put screws in. So I'm ready to do that.
I have it aligned. I took the top part off to make it easier for accessibility.
I'm just trying to Center it properly in here so it doesn't interfere with the garbage disposal.
I'll have to move this; put a zip tie on this later.
Fix that situation. I have my drill here and I'm going to get one screw in the front here first.
There are slotted holes in the clips where this is going to install...
...so you can adjust it. Because once you have a couple or so-now there is a situation I don't want. I gotta fix that.
On the top here there's four screws which allow you to adjust.
In case you have this problem of hitting. So I'm going to adjust this now.
So I don't have this problem anymore. I'm just gonna loosen up these screws...like that.
These screws allow you to reverse it in the opposite direction. So that's the nice thing about this.
It's all adjustable so I can adjust this how I want it.
No problem. That looks like a great spot.
I'm gonna free that area.
I'm going to adjust this one.
Then I'm going to just adjust this one.
Make sure that clip is on there right. The clip grabs the frame,
and you have to make sure it's on there properly so it grabs the wire.
If it doesn't grab the wire properly, then it doesn't work right.
Now I'm gonna tighten the back one. I only have one screw in the bracket installed until I get this adjusted right.
Never tighten everything up until you know that you're all good with alignment.
That looks good. So I'm gonna put another screw in the front here.
Would be better if this was magnetized, but it's no.
Okay that looks good.
Check the door. Door works fine. That's good.
Now I'm gonna put two screws in the back.
Now I'm going to put the last setting screw in place.
Beautiful. Then I'm gonna put the last four in.
I have the last screw here. Nice and smooth. Now to put the top portion on.
There it is.
I'll give you an upper view here. So you can see those are where I put the screws in.
You'll see over here and over there. This is a smooth gliding organizer.
Thanks for watching.